Also move board-h3.h to mach-omap1.
Signed-off-by: Tony Lindgren <tony@atomide.com>
#include <mach/mmc.h>
#include <mach/gpio.h>
#include <mach/mmc.h>
#include <mach/gpio.h>
#if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE)
static int mmc_set_power(struct device *dev, int slot, int power_on,
#if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE)
static int mmc_set_power(struct device *dev, int slot, int power_on,
#include <mach/dma.h>
#include <mach/common.h>
#include <mach/dma.h>
#include <mach/common.h>
+#include "board-h3.h"
+
+/* In OMAP1710 H3 the Ethernet is directly connected to CS1 */
+#define OMAP1710_ETHR_START 0x04000300
+
#define H3_TS_GPIO 48
static int h3_keymap[] = {
#define H3_TS_GPIO 48
static int h3_keymap[] = {
- * arch/arm/plat-omap/include/mach/board-h3.h
+ * arch/arm/mach-omap1/board-h3.h
*
* Copyright (C) 2001 RidgeRun, Inc.
* Copyright (C) 2004 Texas Instruments, Inc.
*
* Copyright (C) 2001 RidgeRun, Inc.
* Copyright (C) 2004 Texas Instruments, Inc.
#ifndef __ASM_ARCH_OMAP_H3_H
#define __ASM_ARCH_OMAP_H3_H
#ifndef __ASM_ARCH_OMAP_H3_H
#define __ASM_ARCH_OMAP_H3_H
-/* In OMAP1710 H3 the Ethernet is directly connected to CS1 */
-#define OMAP1710_ETHR_START 0x04000300
-
#define H3_TPS_GPIO_BASE (OMAP_MAX_GPIO_LINES + 16 /* MPUIO */)
# define H3_TPS_GPIO_MMC_PWR_EN (H3_TPS_GPIO_BASE + 4)
#define H3_TPS_GPIO_BASE (OMAP_MAX_GPIO_LINES + 16 /* MPUIO */)
# define H3_TPS_GPIO_MMC_PWR_EN (H3_TPS_GPIO_BASE + 4)
#include "board-innovator.h"
#endif
#include "board-innovator.h"
#endif
-#ifdef CONFIG_MACH_OMAP_H3
-#include "board-h3.h"
-#endif
-
#ifdef CONFIG_MACH_OMAP_H4
#include "board-h4.h"
#endif
#ifdef CONFIG_MACH_OMAP_H4
#include "board-h4.h"
#endif