if (ret)
return ret;
+ /* The gianfar device will try to use the same ID created below to find
+ * this bus, to coordinate register access (since they share). */
mdio_dev = platform_device_register_simple("fsl-gianfar_mdio",
res.start&0xfffff, &res, 1);
if (IS_ERR(mdio_dev))
of_node_put(mdio);
}
+ /* Get MDIO bus controlled by this eTSEC, if any. Normally only
+ * eTSEC 1 will control an MDIO bus, not necessarily the same
+ * bus that its PHY is on ('mdio' above), so we can't just use
+ * that. What we do is look for a gianfar mdio device that has
+ * overlapping registers with this device. That's really the
+ * whole point, to find the device sharing our registers to
+ * coordinate access with it.
+ */
+ for_each_compatible_node(mdio, NULL, "fsl,gianfar-mdio") {
+ if (of_address_to_resource(mdio, 0, &res))
+ continue;
+
+ if (res.start >= r[0].start && res.end <= r[0].end) {
+ /* Get the ID the mdio bus platform device was
+ * registered with. gfar_data.bus_id is
+ * different because it's for finding a PHY,
+ * while this is for finding a MII bus.
+ */
+ gfar_data.mdio_bus = res.start&0xfffff;
+ of_node_put(mdio);
+ break;
+ }
+ }
+
ret =
platform_device_add_data(gfar_dev, &gfar_data,
sizeof(struct
*/
static void amd8111e_free_ring(struct amd8111e_priv* lp)
{
-
- /* Free transmit and receive skbs */
- amd8111e_free_skbs(lp->amd8111e_net_dev);
-
/* Free transmit and receive descriptor rings */
if(lp->rx_ring){
pci_free_consistent(lp->pci_dev,
amd8111e_disable_interrupt(lp);
amd8111e_stop_chip(lp);
- amd8111e_free_ring(lp);
+
+ /* Free transmit and receive skbs */
+ amd8111e_free_skbs(lp->amd8111e_net_dev);
netif_carrier_off(lp->amd8111e_net_dev);
spin_unlock_irq(&lp->lock);
free_irq(dev->irq, dev);
+ amd8111e_free_ring(lp);
/* Update the statistics before closing */
amd8111e_get_stats(dev);
init_timer(&lp->check_timer);
lp->check_timer.data = (unsigned long)dev;
lp->check_timer.function = at91ether_check_link;
- }
+ } else if (lp->board_data.phy_irq_pin >= 32)
+ gpio_request(lp->board_data.phy_irq_pin, "ethernet_phy");
/* Display ethernet banner */
printk(KERN_INFO "%s: AT91 ethernet at 0x%08x int=%d %s%s (%s)\n",
struct net_device *dev = platform_get_drvdata(pdev);
struct at91_private *lp = netdev_priv(dev);
+ if (lp->board_data.phy_irq_pin >= 32)
+ gpio_free(lp->board_data.phy_irq_pin);
+
unregister_netdev(dev);
free_irq(dev->irq, dev);
dma_free_coherent(NULL, sizeof(struct recv_desc_bufs), lp->dlist, (dma_addr_t)lp->dlist_phys);
if (tpd != ptpd)
memcpy(tpd, ptpd, sizeof(struct tx_packet_desc));
tpd->buffer_addr = cpu_to_le64(buffer_info->dma);
- tpd->word2 = (cpu_to_le16(buffer_info->length) &
+ tpd->word2 &= ~(TPD_BUFLEN_MASK << TPD_BUFLEN_SHIFT);
+ tpd->word2 |= (cpu_to_le16(buffer_info->length) &
TPD_BUFLEN_MASK) << TPD_BUFLEN_SHIFT;
/*
vlan_tag = (vlan_tag << 4) | (vlan_tag >> 13) |
((vlan_tag >> 9) & 0x8);
ptpd->word3 |= 1 << TPD_INS_VL_TAG_SHIFT;
- ptpd->word3 |= (vlan_tag & TPD_VL_TAGGED_MASK) <<
- TPD_VL_TAGGED_SHIFT;
+ ptpd->word2 |= (vlan_tag & TPD_VLANTAG_MASK) <<
+ TPD_VLANTAG_SHIFT;
}
tso = atl1_tso(adapter, skb, ptpd);
#define TPD_PKTNT_MASK 0x0001
#define TPD_PKTINT_SHIFT 15
#define TPD_VLANTAG_MASK 0xFFFF
-#define TPD_VLAN_SHIFT 16
+#define TPD_VLANTAG_SHIFT 16
/* tpd word 3 bits 0:13 */
#define TPD_EOP_MASK 0x0001
/* clear slave from tx_hashtbl */
tx_hash_table = BOND_ALB_INFO(bond).tx_hashtbl;
- index = SLAVE_TLB_INFO(slave).head;
- while (index != TLB_NULL_INDEX) {
- u32 next_index = tx_hash_table[index].next;
- tlb_init_table_entry(&tx_hash_table[index], save_load);
- index = next_index;
+ /* skip this if we've already freed the tx hash table */
+ if (tx_hash_table) {
+ index = SLAVE_TLB_INFO(slave).head;
+ while (index != TLB_NULL_INDEX) {
+ u32 next_index = tx_hash_table[index].next;
+ tlb_init_table_entry(&tx_hash_table[index], save_load);
+ index = next_index;
+ }
}
tlb_init_slave(slave);
unregister_netdevice(bond->dev);
}
+static void bond_destructor(struct net_device *bond_dev)
+{
+ struct bonding *bond = bond_dev->priv;
+
+ if (bond->wq)
+ destroy_workqueue(bond->wq);
+
+ netif_addr_lock_bh(bond_dev);
+ bond_mc_list_destroy(bond);
+ netif_addr_unlock_bh(bond_dev);
+
+ free_netdev(bond_dev);
+}
+
/*
* First release a slave and than destroy the bond if no more slaves iare left.
* Must be under rtnl_lock when this function is called.
continue;
case BOND_LINK_DOWN:
+ if (slave->link_failure_count < UINT_MAX)
+ slave->link_failure_count++;
+
slave->link = BOND_LINK_DOWN;
if (bond->params.mode == BOND_MODE_ACTIVEBACKUP ||
bond_set_mode_ops(bond, bond->params.mode);
- bond_dev->destructor = free_netdev;
+ bond_dev->destructor = bond_destructor;
/* Initialize the device options */
bond_dev->tx_queue_len = 0;
return 0;
}
-/* De-initialize device specific data.
- * Caller must hold rtnl_lock.
- */
-static void bond_deinit(struct net_device *bond_dev)
-{
- struct bonding *bond = bond_dev->priv;
-
- list_del(&bond->bond_list);
-
-#ifdef CONFIG_PROC_FS
- bond_remove_proc_entry(bond);
-#endif
-}
-
static void bond_work_cancel_all(struct bonding *bond)
{
write_lock_bh(&bond->lock);
cancel_delayed_work(&bond->ad_work);
}
+/* De-initialize device specific data.
+ * Caller must hold rtnl_lock.
+ */
+static void bond_deinit(struct net_device *bond_dev)
+{
+ struct bonding *bond = bond_dev->priv;
+
+ list_del(&bond->bond_list);
+
+ bond_work_cancel_all(bond);
+
+#ifdef CONFIG_PROC_FS
+ bond_remove_proc_entry(bond);
+#endif
+}
+
/* Unregister and free all bond devices.
* Caller must hold rtnl_lock.
*/
struct net_device *bond_dev = bond->dev;
bond_work_cancel_all(bond);
- netif_addr_lock_bh(bond_dev);
- bond_mc_list_destroy(bond);
- netif_addr_unlock_bh(bond_dev);
/* Release the bonded slaves */
bond_release_all(bond_dev);
bond_destroy(bond);
struct gfar_mii __iomem *regs =
(void __iomem *)&priv->regs->gfar_mii_regs;
int tbipa = gfar_read(&priv->regs->tbipa);
+ struct mii_bus *bus = gfar_get_miibus(priv);
+
+ if (bus)
+ mutex_lock(&bus->mdio_lock);
+
+ /* If the link is already up, we must already be ok, and don't need to
+ * configure and reset the TBI<->SerDes link. Maybe U-Boot configured
+ * everything for us? Resetting it takes the link down and requires
+ * several seconds for it to come back.
+ */
+ if (gfar_local_mdio_read(regs, tbipa, MII_BMSR) & BMSR_LSTATUS)
+ goto done;
/* Single clk mode, mii mode off(for serdes communication) */
gfar_local_mdio_write(regs, tbipa, MII_TBICON, TBICON_CLK_SELECT);
gfar_local_mdio_write(regs, tbipa, MII_BMCR, BMCR_ANENABLE |
BMCR_ANRESTART | BMCR_FULLDPLX | BMCR_SPEED1000);
+
+ done:
+ if (bus)
+ mutex_unlock(&bus->mdio_lock);
}
static void init_registers(struct net_device *dev)
.remove = gfar_mdio_remove,
};
+static int match_mdio_bus(struct device *dev, void *data)
+{
+ const struct gfar_private *priv = data;
+ const struct platform_device *pdev = to_platform_device(dev);
+
+ return !strcmp(pdev->name, gianfar_mdio_driver.name) &&
+ pdev->id == priv->einfo->mdio_bus;
+}
+
+/* Given a gfar_priv structure, find the mii_bus controlled by this device (not
+ * necessarily the same as the bus the gfar's PHY is on), if one exists.
+ * Normally only the first gianfar controls a mii_bus. */
+struct mii_bus *gfar_get_miibus(const struct gfar_private *priv)
+{
+ /*const*/ struct device *d;
+
+ d = bus_find_device(gianfar_mdio_driver.bus, NULL, (void *)priv,
+ match_mdio_bus);
+ return d ? dev_get_drvdata(d) : NULL;
+}
+
int __init gfar_mdio_init(void)
{
return driver_register(&gianfar_mdio_driver);
#ifndef __GIANFAR_MII_H
#define __GIANFAR_MII_H
+struct gfar_private; /* forward ref */
+
#define MIIMIND_BUSY 0x00000001
#define MIIMIND_NOTVALID 0x00000004
int gfar_local_mdio_write(struct gfar_mii __iomem *regs, int mii_id,
int regnum, u16 value);
int gfar_local_mdio_read(struct gfar_mii __iomem *regs, int mii_id, int regnum);
+struct mii_bus *gfar_get_miibus(const struct gfar_private *priv);
int __init gfar_mdio_init(void);
void gfar_mdio_exit(void);
#endif /* GIANFAR_PHY_H */
#include "myri10ge_mcp.h"
#include "myri10ge_mcp_gen_header.h"
-#define MYRI10GE_VERSION_STR "1.4.3-1.371"
+#define MYRI10GE_VERSION_STR "1.4.3-1.375"
MODULE_DESCRIPTION("Myricom 10G driver (10GbE)");
MODULE_AUTHOR("Maintainer: help@myri.com");
if (tx->req == tx->done) {
tx->queue_active = 0;
put_be32(htonl(1), tx->send_stop);
+ mmiowb();
}
__netif_tx_unlock(dev_queue);
}
if ((mgp->dev->real_num_tx_queues > 1) && tx->queue_active == 0) {
tx->queue_active = 1;
put_be32(htonl(1), tx->send_go);
+ mmiowb();
}
tx->pkt_start++;
if ((avail - count) < MXGEFW_MAX_SEND_DESC) {
struct net_device *ndev)
{
struct resource * res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "smc91x-attrib");
- struct smc_local *lp = netdev_priv(ndev);
if (!res)
return 0;
struct net_device *ndev)
{
struct resource * res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "smc91x-attrib");
- struct smc_local *lp = netdev_priv(ndev);
if (res)
release_mem_region(res->start, ATTRIB_SIZE);
u32 device_flags;
/* board specific information */
u32 board_flags;
- char bus_id[MII_BUS_ID_SIZE];
+ int mdio_bus; /* Bus controlled by us */
+ char bus_id[MII_BUS_ID_SIZE]; /* Bus PHY is on */
u32 phy_id;
u8 mac_addr[6];
phy_interface_t interface;
projects / linux-2.6-omap-h63xx.git / commitdiff