X-Git-Url: http://www.pilppa.org/gitweb/gitweb.cgi?p=linux-2.6-omap-h63xx.git;a=blobdiff_plain;f=drivers%2Fserial%2F8250.c;fp=drivers%2Fserial%2F8250.c;h=67877b1be0dd818e08b634d3d3c1d715603889c5;hp=b4b39811b44544cc76a4c71e00c5c02567a765c2;hb=b934c987ee1764eb09b8843a3ee00eabc24bd52c;hpb=14fc69723d3442ef46f8f82b3f481e82f06a346d

diff --git a/drivers/serial/8250.c b/drivers/serial/8250.c
index b4b39811b44..67877b1be0d 100644
--- a/drivers/serial/8250.c
+++ b/drivers/serial/8250.c
@@ -1596,7 +1596,11 @@ static irqreturn_t serial8250_interrupt(int irq, void *dev_id)
 
 	DEBUG_INTR("end.\n");
 
+#ifdef CONFIG_ARCH_OMAP15XX
+	return IRQ_HANDLED;	/* FIXME: iir status not ready on 1510 */
+#else
 	return IRQ_RETVAL(handled);
+#endif
 }
 
 /*
@@ -2387,6 +2391,19 @@ serial8250_set_termios(struct uart_port *port, struct ktermios *termios,
 			/* emulated UARTs (Lucent Venus 167x) need two steps */
 			serial_outp(up, UART_FCR, UART_FCR_ENABLE_FIFO);
 		}
+
+		/* Note that we need to set ECB to access write water mark
+		 * bits. First allow FCR tx fifo write, then set fcr with
+		 * possible TX fifo settings. */
+		if (uart_config[up->port.type].flags & UART_CAP_EFR) {
+			serial_outp(up, UART_LCR, 0xbf);	/* Access EFR */
+			serial_outp(up, UART_EFR, UART_EFR_ECB);
+			serial_outp(up, UART_LCR, 0x0);		/* Access FCR */
+			serial_outp(up, UART_FCR, fcr);
+			serial_outp(up, UART_LCR, 0xbf);	/* Access EFR */
+			serial_outp(up, UART_EFR, 0);
+			serial_outp(up, UART_LCR, cval);	/* Access FCR */
+        } else
 		serial_outp(up, UART_FCR, fcr);		/* set fcr */
 	}
 	serial8250_set_mctrl(&up->port, up->port.mctrl);