]> www.pilppa.org Git - linux-2.6-omap-h63xx.git/blobdiff - drivers/i2c/chips/Kconfig
Merge current mainline tree into linux-omap tree
[linux-2.6-omap-h63xx.git] / drivers / i2c / chips / Kconfig
index 4c27f8ae7d8aca8ed6d374f6478b2aa2db108a24..bb95b3e9e13485976959e7f22c521906ea29eb62 100644 (file)
@@ -16,43 +16,6 @@ config DS1682
          This driver can also be built as a module.  If so, the module
          will be called ds1682.
 
-config AT24
-       tristate "EEPROMs from most vendors"
-       depends on SYSFS && EXPERIMENTAL
-       help
-         Enable this driver to get read/write support to most I2C EEPROMs,
-         after you configure the driver to know about each EEPROM on
-         your target board.  Use these generic chip names, instead of
-         vendor-specific ones like at24c64 or 24lc02:
-
-            24c00, 24c01, 24c02, spd (readonly 24c02), 24c04, 24c08,
-            24c16, 24c32, 24c64, 24c128, 24c256, 24c512, 24c1024
-
-         Unless you like data loss puzzles, always be sure that any chip
-         you configure as a 24c32 (32 kbit) or larger is NOT really a
-         24c16 (16 kbit) or smaller, and vice versa. Marking the chip
-         as read-only won't help recover from this. Also, if your chip
-         has any software write-protect mechanism you may want to review the
-         code to make sure this driver won't turn it on by accident.
-
-         If you use this with an SMBus adapter instead of an I2C adapter,
-         full functionality is not available.  Only smaller devices are
-         supported (24c16 and below, max 4 kByte).
-
-         This driver can also be built as a module.  If so, the module
-         will be called at24.
-
-config SENSORS_EEPROM
-       tristate "EEPROM reader"
-       depends on EXPERIMENTAL
-       help
-         If you say yes here you get read-only access to the EEPROM data
-         available on modern memory DIMMs and Sony Vaio laptops.  Such
-         EEPROMs could theoretically be available on other devices as well.
-
-         This driver can also be built as a module.  If so, the module
-         will be called eeprom.
-
 config SENSORS_PCF8574
        tristate "Philips PCF8574 and PCF8574A (DEPRECATED)"
        depends on EXPERIMENTAL && GPIO_PCF857X = "n"