From: Stephen Hemminger Date: Sat, 23 Aug 2008 12:16:46 +0000 (-0700) Subject: ipv6: protocol for address routes X-Git-Tag: v2.6.27-rc5~42^2 X-Git-Url: http://www.pilppa.org/gitweb/gitweb.cgi?a=commitdiff_plain;h=f410a1fba7afa79d2992620e874a343fdba28332;p=linux-2.6-omap-h63xx.git ipv6: protocol for address routes This fixes a problem spotted with zebra, but not sure if it is necessary a kernel problem. With IPV6 when an address is added to an interface, Zebra creates a duplicate RIB entry, one as a connected route, and other as a kernel route. When an address is added to an interface the RTN_NEWADDR message causes Zebra to create a connected route. In IPV4 when an address is added to an interface a RTN_NEWROUTE message is set to user space with the protocol RTPROT_KERNEL. Zebra ignores these messages, because it already has the connected route. The problem is that route created in IPV6 has route protocol == RTPROT_BOOT. Was this a design decision or a bug? This fixes it. Same patch applies to both net-2.6 and stable. Signed-off-by: Stephen Hemminger Signed-off-by: David S. Miller --- diff --git a/net/ipv6/addrconf.c b/net/ipv6/addrconf.c index e2d3b7580b7..7b6a584b62d 100644 --- a/net/ipv6/addrconf.c +++ b/net/ipv6/addrconf.c @@ -1688,6 +1688,7 @@ addrconf_prefix_route(struct in6_addr *pfx, int plen, struct net_device *dev, .fc_dst_len = plen, .fc_flags = RTF_UP | flags, .fc_nlinfo.nl_net = dev_net(dev), + .fc_protocol = RTPROT_KERNEL, }; ipv6_addr_copy(&cfg.fc_dst, pfx);