From: Joe Carnuccio Date: Thu, 22 Jan 2009 17:45:36 +0000 (-0800) Subject: [SCSI] qla2xxx: Correct descriptions in flash manipulation routines. X-Git-Tag: v2.6.29-rc3~8^2~4 X-Git-Url: http://www.pilppa.org/gitweb/gitweb.cgi?a=commitdiff_plain;h=b872ca4081c480e3d76443282ffd7f206321f50f;p=linux-2.6-omap-h63xx.git [SCSI] qla2xxx: Correct descriptions in flash manipulation routines. When clearing the flash device's SR, the comment is incorrect... clearing the SR is 2 steps: 1. the SR protect bit is 1, so the first write zero clears only that bit, 2. the SR protect bit is now 0, so the next write zero clears the remaining bits. The sector erase debug print more correctly identifies that the erase failed. Signed-off-by: Andrew Vasquez Signed-off-by: James Bottomley --- diff --git a/drivers/scsi/qla2xxx/qla_sup.c b/drivers/scsi/qla2xxx/qla_sup.c index ed9582603af..9c3b694c049 100644 --- a/drivers/scsi/qla2xxx/qla_sup.c +++ b/drivers/scsi/qla2xxx/qla_sup.c @@ -944,9 +944,9 @@ qla24xx_unprotect_flash(struct qla_hw_data *ha) if (!ha->fdt_wrt_disable) return; - /* Disable flash write-protection. */ + /* Disable flash write-protection, first clear SR protection bit */ qla24xx_write_flash_dword(ha, flash_conf_addr(ha, 0x101), 0); - /* Some flash parts need an additional zero-write to clear bits.*/ + /* Then write zero again to clear remaining SR bits.*/ qla24xx_write_flash_dword(ha, flash_conf_addr(ha, 0x101), 0); } @@ -1021,7 +1021,7 @@ qla24xx_write_flash_data(scsi_qla_host_t *vha, uint32_t *dwptr, uint32_t faddr, (fdata & 0xff00) |((fdata << 16) & 0xff0000) | ((fdata >> 16) & 0xff)); if (ret != QLA_SUCCESS) { - DEBUG9(qla_printk("Unable to flash sector: " + DEBUG9(qla_printk("Unable to erase sector: " "address=%x.\n", faddr)); break; }