From: Sergei Shtylyov Date: Fri, 8 Jun 2007 13:14:32 +0000 (+0200) Subject: hpt366: disallow Ultra133 for HPT374 X-Git-Tag: v2.6.22-rc5~54^2~2 X-Git-Url: http://www.pilppa.org/gitweb/gitweb.cgi?a=commitdiff_plain;h=278978e953a35a2ddf27f197003b29da54e31908;p=linux-2.6-omap-h63xx.git hpt366: disallow Ultra133 for HPT374 Eliminate UltraATA/133 support for HPT374 -- the chip isn't capable of this mode according to the manual, and doesn't even seem to tolerate 66 MHz DPLL clock... Signed-off-by: Sergei Shtylyov Cc: Geller Sandor Signed-off-by: Bartlomiej Zolnierkiewicz --- diff --git a/drivers/ide/pci/hpt366.c b/drivers/ide/pci/hpt366.c index fcbc5605b38..ce8a5449a57 100644 --- a/drivers/ide/pci/hpt366.c +++ b/drivers/ide/pci/hpt366.c @@ -1,5 +1,5 @@ /* - * linux/drivers/ide/pci/hpt366.c Version 1.03 May 4, 2007 + * linux/drivers/ide/pci/hpt366.c Version 1.04 Jun 4, 2007 * * Copyright (C) 1999-2003 Andre Hedrick * Portions Copyright (C) 2001 Sun Microsystems, Inc. @@ -106,7 +106,8 @@ * switch to calculating PCI clock frequency based on the chip's base DPLL * frequency * - switch to using the DPLL clock and enable UltraATA/133 mode by default on - * anything newer than HPT370/A + * anything newer than HPT370/A (except HPT374 that is not capable of this + * mode according to the manual) * - fold PCI clock detection and DPLL setup code into init_chipset_hpt366(), * also fixing the interchanged 25/40 MHz PCI clock cases for HPT36x chips; * unify HPT36x/37x timing setup code and the speedproc handlers by joining @@ -365,7 +366,6 @@ static u32 sixty_six_base_hpt37x[] = { }; #define HPT366_DEBUG_DRIVE_INFO 0 -#define HPT374_ALLOW_ATA133_6 1 #define HPT371_ALLOW_ATA133_6 1 #define HPT302_ALLOW_ATA133_6 1 #define HPT372_ALLOW_ATA133_6 1 @@ -450,7 +450,7 @@ static struct hpt_info hpt370a __devinitdata = { static struct hpt_info hpt374 __devinitdata = { .chip_type = HPT374, - .max_mode = HPT374_ALLOW_ATA133_6 ? 4 : 3, + .max_mode = 3, .dpll_clk = 48, .settings = hpt37x_settings };