#include <linux/sched.h>
#include <linux/interrupt.h>
#include <linux/ptrace.h>
+#include <linux/sysdev.h>
+#include <linux/err.h>
#include <asm/hardware.h>
+#include <asm/hardware/clock.h>
#include <asm/irq.h>
#include <asm/arch/irqs.h>
#include <asm/arch/gpio.h>
#define OMAP1610_GPIO_SYSSTATUS 0x0014
#define OMAP1610_GPIO_IRQSTATUS1 0x0018
#define OMAP1610_GPIO_IRQENABLE1 0x001c
+#define OMAP1610_GPIO_WAKEUPENABLE 0x0028
#define OMAP1610_GPIO_DATAIN 0x002c
#define OMAP1610_GPIO_DATAOUT 0x0030
#define OMAP1610_GPIO_DIRECTION 0x0034
#define OMAP1610_GPIO_EDGE_CTRL1 0x0038
#define OMAP1610_GPIO_EDGE_CTRL2 0x003c
#define OMAP1610_GPIO_CLEAR_IRQENABLE1 0x009c
+#define OMAP1610_GPIO_CLEAR_WAKEUPENA 0x00a8
#define OMAP1610_GPIO_CLEAR_DATAOUT 0x00b0
#define OMAP1610_GPIO_SET_IRQENABLE1 0x00dc
+#define OMAP1610_GPIO_SET_WAKEUPENA 0x00e8
#define OMAP1610_GPIO_SET_DATAOUT 0x00f0
/*
u16 virtual_irq_start;
u8 method;
u32 reserved_map;
+ u32 suspend_wakeup;
+ u32 saved_wakeup;
spinlock_t lock;
};
_enable_gpio_irqbank(bank, 1 << get_gpio_index(gpio), enable);
}
+/*
+ * Note that ENAWAKEUP needs to be enabled in GPIO_SYSCONFIG register.
+ * 1510 does not seem to have a wake-up register. If JTAG is connected
+ * to the target, system will wake up always on GPIO events. While
+ * system is running all registered GPIO interrupts need to have wake-up
+ * enabled. When system is suspended, only selected GPIO interrupts need
+ * to have wake-up enabled.
+ */
+static void _set_gpio_wakeup(struct gpio_bank *bank, int gpio, int enable)
+{
+ switch (bank->method) {
+ case METHOD_GPIO_1610:
+ spin_lock(&bank->lock);
+ if (enable)
+ bank->suspend_wakeup |= (1 << gpio);
+ else
+ bank->suspend_wakeup &= ~(1 << gpio);
+ spin_unlock(&bank->lock);
+ break;
+ default:
+ printk(KERN_ERR "Can't enable GPIO wakeup for method %i\n",
+ bank->method);
+ return;
+ }
+}
+
+/* Use disable_irq_wake() and enable_irq_wake() functions from drivers */
+static int gpio_wake_enable(unsigned int irq, unsigned int enable)
+{
+ unsigned int gpio = irq - IH_GPIO_BASE;
+ struct gpio_bank *bank;
+
+ if (check_gpio(gpio) < 0)
+ return -ENODEV;
+ bank = get_gpio_bank(gpio);
+ spin_lock(&bank->lock);
+ _set_gpio_wakeup(bank, get_gpio_index(gpio), enable);
+ spin_unlock(&bank->lock);
+
+ return 0;
+}
+
int omap_request_gpio(int gpio)
{
struct gpio_bank *bank;
reg = bank->base + OMAP1510_GPIO_PIN_CONTROL;
__raw_writel(__raw_readl(reg) | (1 << get_gpio_index(gpio)), reg);
}
+#endif
+#ifdef CONFIG_ARCH_OMAP16XX
+ if (bank->method == METHOD_GPIO_1610) {
+ /* Enable wake-up during idle for dynamic tick */
+ u32 reg = bank->base + OMAP1610_GPIO_SET_WAKEUPENA;
+ __raw_writel(1 << get_gpio_index(gpio), reg);
+ }
#endif
spin_unlock(&bank->lock);
spin_unlock(&bank->lock);
return;
}
+#ifdef CONFIG_ARCH_OMAP16XX
+ if (bank->method == METHOD_GPIO_1610) {
+ /* Disable wake-up during idle for dynamic tick */
+ u32 reg = bank->base + OMAP1610_GPIO_CLEAR_WAKEUPENA;
+ __raw_writel(1 << get_gpio_index(gpio), reg);
+ }
+#endif
bank->reserved_map &= ~(1 << get_gpio_index(gpio));
_set_gpio_direction(bank, get_gpio_index(gpio), 1);
_set_gpio_irqenable(bank, gpio, 0);
.ack = gpio_ack_irq,
.mask = gpio_mask_irq,
.unmask = gpio_unmask_irq,
+ .wake = gpio_wake_enable,
};
static struct irqchip mpuio_irq_chip = {
};
static int initialized = 0;
+static struct clk * gpio_ck = 0;
static int __init _omap_gpio_init(void)
{
initialized = 1;
+ if (cpu_is_omap1510()) {
+ gpio_ck = clk_get(0, "arm_gpio_ck");
+ if (IS_ERR(gpio_ck))
+ printk("Could not get arm_gpio_ck\n");
+ else
+ clk_use(gpio_ck);
+ }
+
#ifdef CONFIG_ARCH_OMAP1510
if (cpu_is_omap1510()) {
printk(KERN_INFO "OMAP1510 GPIO hardware\n");
if (bank->method == METHOD_GPIO_1610) {
__raw_writew(0x0000, bank->base + OMAP1610_GPIO_IRQENABLE1);
__raw_writew(0xffff, bank->base + OMAP1610_GPIO_IRQSTATUS1);
+ __raw_writew(0x0014, bank->base + OMAP1610_GPIO_SYSCONFIG);
}
#endif
#ifdef CONFIG_ARCH_OMAP730
return 0;
}
+#ifdef CONFIG_ARCH_OMAP16XX
+static int omap_gpio_suspend(struct sys_device *dev, u32 state)
+{
+ int i;
+
+ if (cpu_is_omap1510())
+ return 0;
+
+ for (i = 0; i < gpio_bank_count; i++) {
+ struct gpio_bank *bank = &gpio_bank[i];
+ u32 wake_status = bank->base + OMAP1610_GPIO_WAKEUPENABLE;
+ u32 wake_clear = bank->base + OMAP1610_GPIO_CLEAR_WAKEUPENA;
+ u32 wake_set = bank->base + OMAP1610_GPIO_SET_WAKEUPENA;
+
+ if (bank->method != METHOD_GPIO_1610)
+ continue;
+
+ spin_lock(&bank->lock);
+ bank->saved_wakeup = __raw_readl(wake_status);
+ __raw_writel(0xffffffff, wake_clear);
+ __raw_writel(bank->suspend_wakeup, wake_set);
+ spin_unlock(&bank->lock);
+ }
+
+ return 0;
+}
+
+static int omap_gpio_resume(struct sys_device *dev)
+{
+ int i;
+
+ if (cpu_is_omap1510())
+ return 0;
+
+ for (i = 0; i < gpio_bank_count; i++) {
+ struct gpio_bank *bank = &gpio_bank[i];
+ u32 wake_clear = bank->base + OMAP1610_GPIO_CLEAR_WAKEUPENA;
+ u32 wake_set = bank->base + OMAP1610_GPIO_SET_WAKEUPENA;
+
+ if (bank->method != METHOD_GPIO_1610)
+ continue;
+
+ spin_lock(&bank->lock);
+ __raw_writel(0xffffffff, wake_clear);
+ __raw_writel(bank->saved_wakeup, wake_set);
+ spin_unlock(&bank->lock);
+ }
+
+ return 0;
+}
+
+static struct sysdev_class omap_gpio_sysclass = {
+ set_kset_name("gpio"),
+ .suspend = omap_gpio_suspend,
+ .resume = omap_gpio_resume,
+};
+
+static struct sys_device omap_gpio_device = {
+ .id = 0,
+ .cls = &omap_gpio_sysclass,
+};
+#endif
+
/*
* This may get called early from board specific init
*/
return 0;
}
+static int __init omap_gpio_sysinit(void)
+{
+ int ret = 0;
+
+ if (!initialized)
+ ret = _omap_gpio_init();
+
+#ifdef CONFIG_ARCH_OMAP16XX
+ if (cpu_is_omap16xx()) {
+ if (ret == 0) {
+ ret = sysdev_class_register(&omap_gpio_sysclass);
+ if (ret == 0)
+ ret = sysdev_register(&omap_gpio_device);
+ }
+ }
+#endif
+
+ return ret;
+}
+
EXPORT_SYMBOL(omap_request_gpio);
EXPORT_SYMBOL(omap_free_gpio);
EXPORT_SYMBOL(omap_set_gpio_direction);
EXPORT_SYMBOL(omap_get_gpio_datain);
EXPORT_SYMBOL(omap_set_gpio_edge_ctrl);
-arch_initcall(omap_gpio_init);
+arch_initcall(omap_gpio_sysinit);
projects / linux-2.6-omap-h63xx.git / commitdiff