-/* Switch the tuner to a specific tuner mode. Replacement of AUDC_SET_RADIO */
-#define VIDIOC_INT_S_TUNER_MODE _IOW('d', 93, enum v4l2_tuner_type)
-
-/* Generic standby command. Passing -1 (all bits set to 1) will put the whole
- chip into standby mode, value 0 will make the chip fully active. Specific
- bits can be used by certain chips to enable/disable specific subsystems.
- Replacement of TUNER_SET_STANDBY. */
-#define VIDIOC_INT_S_STANDBY _IOW('d', 94, u32)
-
-/* 100, 101 used by VIDIOC_DBG_[SG]_REGISTER */
-
-/* Generic reset command. The argument selects which subsystems to reset.
- Passing 0 will always reset the whole chip. */
-#define VIDIOC_INT_RESET _IOW ('d', 102, u32)
-
-/* Set the frequency (in Hz) of the audio clock output.
- Used to slave an audio processor to the video decoder, ensuring that audio
- and video remain synchronized.
- Usual values for the frequency are 48000, 44100 or 32000 Hz.
- If the frequency is not supported, then -EINVAL is returned. */
-#define VIDIOC_INT_AUDIO_CLOCK_FREQ _IOW ('d', 103, u32)
-
-/* Video decoders that support sliced VBI need to implement this ioctl.
- Field p of the v4l2_sliced_vbi_line struct is set to the start of the VBI
- data that was generated by the decoder. The driver then parses the sliced
- VBI data and sets the other fields in the struct accordingly. The pointer p
- is updated to point to the start of the payload which can be copied
- verbatim into the data field of the v4l2_sliced_vbi_data struct. If no
- valid VBI data was found, then the type field is set to 0 on return. */
-#define VIDIOC_INT_DECODE_VBI_LINE _IOWR('d', 104, struct v4l2_decode_vbi_line)
-
-/* Used to generate VBI signals on a video signal. v4l2_sliced_vbi_data is
- filled with the data packets that should be output. Note that if you set
- the line field to 0, then that VBI signal is disabled. If no
- valid VBI data was found, then the type field is set to 0 on return. */
-#define VIDIOC_INT_S_VBI_DATA _IOW ('d', 105, struct v4l2_sliced_vbi_data)
-
-/* Used to obtain the sliced VBI packet from a readback register. Not all
- video decoders support this. If no data is available because the readback
- register contains invalid or erroneous data -EIO is returned. Note that
- you must fill in the 'id' member and the 'field' member (to determine
- whether CC data from the first or second field should be obtained). */
-#define VIDIOC_INT_G_VBI_DATA _IOWR('d', 106, struct v4l2_sliced_vbi_data)
-
-/* Sets I2S speed in bps. This is used to provide a standard way to select I2S
- clock used by driving digital audio streams at some board designs.
- Usual values for the frequency are 1024000 and 2048000.
- If the frequency is not supported, then -EINVAL is returned. */
-#define VIDIOC_INT_I2S_CLOCK_FREQ _IOW ('d', 108, u32)
-
-/* Routing definition, device dependent. It specifies which inputs (if any)
- should be routed to which outputs (if any). */