+
+int asd_I_T_nexus_reset(struct domain_device *dev)
+{
+ int res, tmp_res, i;
+ struct sas_phy *phy = sas_find_local_phy(dev);
+ /* Standard mandates link reset for ATA (type 0) and
+ * hard reset for SSP (type 1) */
+ int reset_type = (dev->dev_type == SATA_DEV ||
+ (dev->tproto & SAS_PROTOCOL_STP)) ? 0 : 1;
+
+ asd_clear_nexus_I_T(dev, NEXUS_PHASE_PRE);
+ /* send a hard reset */
+ ASD_DPRINTK("sending %s reset to %s\n",
+ reset_type ? "hard" : "soft", phy->dev.bus_id);
+ res = sas_phy_reset(phy, reset_type);
+ if (res == TMF_RESP_FUNC_COMPLETE) {
+ /* wait for the maximum settle time */
+ msleep(500);
+ /* clear all outstanding commands (keep nexus suspended) */
+ asd_clear_nexus_I_T(dev, NEXUS_PHASE_POST);
+ }
+ for (i = 0 ; i < 3; i++) {
+ tmp_res = asd_clear_nexus_I_T(dev, NEXUS_PHASE_RESUME);
+ if (tmp_res == TC_RESUME)
+ return res;
+ msleep(500);
+ }
+
+ /* This is a bit of a problem: the sequencer is still suspended
+ * and is refusing to resume. Hope it will resume on a bigger hammer
+ * or the disk is lost */
+ dev_printk(KERN_ERR, &phy->dev,
+ "Failed to resume nexus after reset 0x%x\n", tmp_res);
+
+ return TMF_RESP_FUNC_FAILED;
+}