X-Git-Url: http://www.pilppa.org/gitweb/gitweb.cgi?a=blobdiff_plain;f=arch%2Farm%2Fmach-at91%2Fboard-sam9261ek.c;h=3c73825b58dea2fdaf6a4b530d6a7f32f32b164f;hb=a3da12229f4f9bee2ed66ac34a54a4e8b74bcbcb;hp=f71ff750b3d24bb70172abeceafdbf6143e9dbb8;hpb=d7a2415f7a48ce4fc16cc769f96d0df818648837;p=linux-2.6-omap-h63xx.git

diff --git a/arch/arm/mach-at91/board-sam9261ek.c b/arch/arm/mach-at91/board-sam9261ek.c
index f71ff750b3d..3c73825b58d 100644
--- a/arch/arm/mach-at91/board-sam9261ek.c
+++ b/arch/arm/mach-at91/board-sam9261ek.c
@@ -49,17 +49,6 @@
 #include "generic.h"
 
 
-/*
- * Serial port configuration.
- *    0 .. 2 = USART0 .. USART2
- *    3      = DBGU
- */
-static struct at91_uart_config __initdata ek_uart_config = {
-	.console_tty	= 0,				/* ttyS0 */
-	.nr_tty		= 1,
-	.tty_map	= { 3, -1, -1, -1 }		/* ttyS0, ..., ttyS3 */
-};
-
 static void __init ek_map_io(void)
 {
 	/* Initialize processor: 18.432 MHz crystal */
@@ -68,8 +57,11 @@ static void __init ek_map_io(void)
 	/* Setup the LEDs */
 	at91_init_leds(AT91_PIN_PA13, AT91_PIN_PA14);
 
-	/* Setup the serial ports and console */
-	at91_init_serial(&ek_uart_config);
+	/* DGBU on ttyS0. (Rx & Tx only) */
+	at91_register_uart(0, 0, 0);
+
+	/* set serial console to ttyS0 (ie, DBGU) */
+	at91_set_serial_console(0);
 }
 
 static void __init ek_init_irq(void)