X-Git-Url: http://www.pilppa.org/gitweb/gitweb.cgi?a=blobdiff_plain;f=arch%2Farm%2Fmach-at91%2Fboard-kb9202.c;h=cb065febd95e6e35bf9145accdf72b4946ec9284;hb=19750336d4cc3a171a5aa5f9a258fb81066cc45e;hp=4b39b9cda75b48e84b9f49bae5c4f302efa27480;hpb=7b2253418cc12877620b4d6782831e8643ab0afa;p=linux-2.6-omap-h63xx.git

diff --git a/arch/arm/mach-at91/board-kb9202.c b/arch/arm/mach-at91/board-kb9202.c
index 4b39b9cda75..cb065febd95 100644
--- a/arch/arm/mach-at91/board-kb9202.c
+++ b/arch/arm/mach-at91/board-kb9202.c
@@ -37,19 +37,10 @@
 #include <asm/arch/board.h>
 #include <asm/arch/gpio.h>
 
-#include "generic.h"
+#include <asm/arch/at91rm9200_mc.h>
 
+#include "generic.h"
 
-/*
- * Serial port configuration.
- *    0 .. 3 = USART0 .. USART3
- *    4      = DBGU
- */
-static struct at91_uart_config __initdata kb9202_uart_config = {
-	.console_tty	= 0,					/* ttyS0 */
-	.nr_tty		= 3,
-	.tty_map	= { 4, 0, 1, -1, -1 }			/* ttyS0, ..., ttyS4 */
-};
 
 static void __init kb9202_map_io(void)
 {
@@ -59,8 +50,20 @@ static void __init kb9202_map_io(void)
 	/* Set up the LEDs */
 	at91_init_leds(AT91_PIN_PC19, AT91_PIN_PC18);
 
-	/* Setup the serial ports and console */
-	at91_init_serial(&kb9202_uart_config);
+	/* DBGU on ttyS0. (Rx & Tx only) */
+	at91_register_uart(0, 0, 0);
+
+	/* USART0 on ttyS1 (Rx & Tx only) */
+	at91_register_uart(AT91RM9200_ID_US0, 1, 0);
+
+	/* USART1 on ttyS2 (Rx & Tx only) - IRDA (optional) */
+	at91_register_uart(AT91RM9200_ID_US1, 2, 0);
+
+	/* USART3 on ttyS3 (Rx, Tx, CTS, RTS) - RS485 (optional) */
+	at91_register_uart(AT91RM9200_ID_US3, 3, ATMEL_UART_CTS | ATMEL_UART_RTS);
+
+	/* set serial console to ttyS0 (ie, DBGU) */
+	at91_set_serial_console(0);
 }
 
 static void __init kb9202_init_irq(void)