*
* @IEEE80211_HW_MFP_CAPABLE:
* Hardware supports management frame protection (MFP, IEEE 802.11w).
+ *
+ * @IEEE80211_HW_BEACON_FILTER:
+ * Hardware supports dropping of irrelevant beacon frames to
+ * avoid waking up cpu.
*/
enum ieee80211_hw_flags {
IEEE80211_HW_RX_INCLUDES_FCS = 1<<1,
IEEE80211_HW_PS_NULLFUNC_STACK = 1<<11,
IEEE80211_HW_SUPPORTS_DYNAMIC_PS = 1<<12,
IEEE80211_HW_MFP_CAPABLE = 1<<13,
+ IEEE80211_HW_BEACON_FILTER = 1<<14,
};
/**
* value, or by the stack if all nullfunc handling is in the stack.
*/
+/**
+ * DOC: Beacon filter support
+ *
+ * Some hardware have beacon filter support to reduce host cpu wakeups
+ * which will reduce system power consumption. It usuallly works so that
+ * the firmware creates a checksum of the beacon but omits all constantly
+ * changing elements (TSF, TIM etc). Whenever the checksum changes the
+ * beacon is forwarded to the host, otherwise it will be just dropped. That
+ * way the host will only receive beacons where some relevant information
+ * (for example ERP protection or WMM settings) have changed.
+ *
+ * Beacon filter support is informed with %IEEE80211_HW_BEACON_FILTER flag.
+ * The driver needs to enable beacon filter support whenever power save is
+ * enabled, that is %IEEE80211_CONF_PS is set. When power save is enabled,
+ * the stack will not check for beacon miss at all and the driver needs to
+ * notify about complete loss of beacons with ieee80211_beacon_loss().
+ */
+
/**
* DOC: Frame filtering
*
struct ieee80211_sta *ieee80211_find_sta(struct ieee80211_hw *hw,
const u8 *addr);
+/**
+ * ieee80211_beacon_loss - inform hardware does not receive beacons
+ *
+ * @vif: &struct ieee80211_vif pointer from &struct ieee80211_if_init_conf.
+ *
+ * When beacon filtering is enabled with IEEE80211_HW_BEACON_FILTERING and
+ * IEEE80211_CONF_PS is set, the driver needs to inform whenever the
+ * hardware is not receiving beacons with this function.
+ */
+void ieee80211_beacon_loss(struct ieee80211_vif *vif);
/* Rate control API */