#endif
spinlock_t lock; /* lock for controller
configuration */
-
void *driver_data[I2O_MAX_DRIVERS]; /* storage for drivers */
};
};
#endif
-/**
- * i2o_sg_tablesize - Calculate the maximum number of elements in a SGL
- * @c: I2O controller for which the calculation should be done
- * @body_size: maximum body size used for message in 32-bit words.
- *
- * Return the maximum number of SG elements in a SG list.
- */
-static inline u16 i2o_sg_tablesize(struct i2o_controller *c, u16 body_size)
-{
- i2o_status_block *sb = c->status_block.virt;
- u16 sg_count =
- (sb->inbound_frame_size - sizeof(struct i2o_message) / 4) -
- body_size;
-
- if (c->pae_support) {
- /*
- * for 64-bit a SG attribute element must be added and each
- * SG element needs 12 bytes instead of 8.
- */
- sg_count -= 2;
- sg_count /= 3;
- } else
- sg_count /= 2;
-
- if (c->short_req && (sg_count > 8))
- sg_count = 8;
-
- return sg_count;
-};
-
-/**
- * i2o_dma_map_single - Map pointer to controller and fill in I2O message.
- * @c: I2O controller
- * @ptr: pointer to the data which should be mapped
- * @size: size of data in bytes
- * @direction: DMA_TO_DEVICE / DMA_FROM_DEVICE
- * @sg_ptr: pointer to the SG list inside the I2O message
- *
- * This function does all necessary DMA handling and also writes the I2O
- * SGL elements into the I2O message. For details on DMA handling see also
- * dma_map_single(). The pointer sg_ptr will only be set to the end of the
- * SG list if the allocation was successful.
- *
- * Returns DMA address which must be checked for failures using
- * dma_mapping_error().
- */
-static inline dma_addr_t i2o_dma_map_single(struct i2o_controller *c, void *ptr,
+extern u16 i2o_sg_tablesize(struct i2o_controller *c, u16 body_size);
+extern dma_addr_t i2o_dma_map_single(struct i2o_controller *c, void *ptr,
size_t size,
enum dma_data_direction direction,
- u32 ** sg_ptr)
-{
- u32 sg_flags;
- u32 *mptr = *sg_ptr;
- dma_addr_t dma_addr;
-
- switch (direction) {
- case DMA_TO_DEVICE:
- sg_flags = 0xd4000000;
- break;
- case DMA_FROM_DEVICE:
- sg_flags = 0xd0000000;
- break;
- default:
- return 0;
- }
-
- dma_addr = dma_map_single(&c->pdev->dev, ptr, size, direction);
- if (!dma_mapping_error(&c->pdev->dev, dma_addr)) {
-#ifdef CONFIG_I2O_EXT_ADAPTEC_DMA64
- if ((sizeof(dma_addr_t) > 4) && c->pae_support) {
- *mptr++ = cpu_to_le32(0x7C020002);
- *mptr++ = cpu_to_le32(PAGE_SIZE);
- }
-#endif
-
- *mptr++ = cpu_to_le32(sg_flags | size);
- *mptr++ = cpu_to_le32(i2o_dma_low(dma_addr));
-#ifdef CONFIG_I2O_EXT_ADAPTEC_DMA64
- if ((sizeof(dma_addr_t) > 4) && c->pae_support)
- *mptr++ = cpu_to_le32(i2o_dma_high(dma_addr));
-#endif
- *sg_ptr = mptr;
- }
- return dma_addr;
-};
-
-/**
- * i2o_dma_map_sg - Map a SG List to controller and fill in I2O message.
- * @c: I2O controller
- * @sg: SG list to be mapped
- * @sg_count: number of elements in the SG list
- * @direction: DMA_TO_DEVICE / DMA_FROM_DEVICE
- * @sg_ptr: pointer to the SG list inside the I2O message
- *
- * This function does all necessary DMA handling and also writes the I2O
- * SGL elements into the I2O message. For details on DMA handling see also
- * dma_map_sg(). The pointer sg_ptr will only be set to the end of the SG
- * list if the allocation was successful.
- *
- * Returns 0 on failure or 1 on success.
- */
-static inline int i2o_dma_map_sg(struct i2o_controller *c,
+ u32 ** sg_ptr);
+extern int i2o_dma_map_sg(struct i2o_controller *c,
struct scatterlist *sg, int sg_count,
enum dma_data_direction direction,
- u32 ** sg_ptr)
-{
- u32 sg_flags;
- u32 *mptr = *sg_ptr;
-
- switch (direction) {
- case DMA_TO_DEVICE:
- sg_flags = 0x14000000;
- break;
- case DMA_FROM_DEVICE:
- sg_flags = 0x10000000;
- break;
- default:
- return 0;
- }
-
- sg_count = dma_map_sg(&c->pdev->dev, sg, sg_count, direction);
- if (!sg_count)
- return 0;
-
-#ifdef CONFIG_I2O_EXT_ADAPTEC_DMA64
- if ((sizeof(dma_addr_t) > 4) && c->pae_support) {
- *mptr++ = cpu_to_le32(0x7C020002);
- *mptr++ = cpu_to_le32(PAGE_SIZE);
- }
-#endif
-
- while (sg_count-- > 0) {
- if (!sg_count)
- sg_flags |= 0xC0000000;
- *mptr++ = cpu_to_le32(sg_flags | sg_dma_len(sg));
- *mptr++ = cpu_to_le32(i2o_dma_low(sg_dma_address(sg)));
-#ifdef CONFIG_I2O_EXT_ADAPTEC_DMA64
- if ((sizeof(dma_addr_t) > 4) && c->pae_support)
- *mptr++ = cpu_to_le32(i2o_dma_high(sg_dma_address(sg)));
-#endif
- sg = sg_next(sg);
- }
- *sg_ptr = mptr;
-
- return 1;
-};
-
-/**
- * i2o_dma_alloc - Allocate DMA memory
- * @dev: struct device pointer to the PCI device of the I2O controller
- * @addr: i2o_dma struct which should get the DMA buffer
- * @len: length of the new DMA memory
- * @gfp_mask: GFP mask
- *
- * Allocate a coherent DMA memory and write the pointers into addr.
- *
- * Returns 0 on success or -ENOMEM on failure.
- */
-static inline int i2o_dma_alloc(struct device *dev, struct i2o_dma *addr,
- size_t len, gfp_t gfp_mask)
-{
- struct pci_dev *pdev = to_pci_dev(dev);
- int dma_64 = 0;
-
- if ((sizeof(dma_addr_t) > 4) && (pdev->dma_mask == DMA_64BIT_MASK)) {
- dma_64 = 1;
- if (pci_set_dma_mask(pdev, DMA_32BIT_MASK))
- return -ENOMEM;
- }
-
- addr->virt = dma_alloc_coherent(dev, len, &addr->phys, gfp_mask);
-
- if ((sizeof(dma_addr_t) > 4) && dma_64)
- if (pci_set_dma_mask(pdev, DMA_64BIT_MASK))
- printk(KERN_WARNING "i2o: unable to set 64-bit DMA");
-
- if (!addr->virt)
- return -ENOMEM;
-
- memset(addr->virt, 0, len);
- addr->len = len;
-
- return 0;
-};
-
-/**
- * i2o_dma_free - Free DMA memory
- * @dev: struct device pointer to the PCI device of the I2O controller
- * @addr: i2o_dma struct which contains the DMA buffer
- *
- * Free a coherent DMA memory and set virtual address of addr to NULL.
- */
-static inline void i2o_dma_free(struct device *dev, struct i2o_dma *addr)
-{
- if (addr->virt) {
- if (addr->phys)
- dma_free_coherent(dev, addr->len, addr->virt,
- addr->phys);
- else
- kfree(addr->virt);
- addr->virt = NULL;
- }
-};
-
-/**
- * i2o_dma_realloc - Realloc DMA memory
- * @dev: struct device pointer to the PCI device of the I2O controller
- * @addr: pointer to a i2o_dma struct DMA buffer
- * @len: new length of memory
- * @gfp_mask: GFP mask
- *
- * If there was something allocated in the addr, free it first. If len > 0
- * than try to allocate it and write the addresses back to the addr
- * structure. If len == 0 set the virtual address to NULL.
- *
- * Returns the 0 on success or negative error code on failure.
- */
-static inline int i2o_dma_realloc(struct device *dev, struct i2o_dma *addr,
- size_t len, gfp_t gfp_mask)
-{
- i2o_dma_free(dev, addr);
-
- if (len)
- return i2o_dma_alloc(dev, addr, len, gfp_mask);
-
- return 0;
-};
-
-/*
- * i2o_pool_alloc - Allocate an slab cache and mempool
- * @mempool: pointer to struct i2o_pool to write data into.
- * @name: name which is used to identify cache
- * @size: size of each object
- * @min_nr: minimum number of objects
- *
- * First allocates a slab cache with name and size. Then allocates a
- * mempool which uses the slab cache for allocation and freeing.
- *
- * Returns 0 on success or negative error code on failure.
- */
-static inline int i2o_pool_alloc(struct i2o_pool *pool, const char *name,
- size_t size, int min_nr)
-{
- pool->name = kmalloc(strlen(name) + 1, GFP_KERNEL);
- if (!pool->name)
- goto exit;
- strcpy(pool->name, name);
-
- pool->slab =
- kmem_cache_create(pool->name, size, 0, SLAB_HWCACHE_ALIGN, NULL);
- if (!pool->slab)
- goto free_name;
-
- pool->mempool = mempool_create_slab_pool(min_nr, pool->slab);
- if (!pool->mempool)
- goto free_slab;
-
- return 0;
-
- free_slab:
- kmem_cache_destroy(pool->slab);
-
- free_name:
- kfree(pool->name);
-
- exit:
- return -ENOMEM;
-};
-
-/*
- * i2o_pool_free - Free slab cache and mempool again
- * @mempool: pointer to struct i2o_pool which should be freed
- *
- * Note that you have to return all objects to the mempool again before
- * calling i2o_pool_free().
- */
-static inline void i2o_pool_free(struct i2o_pool *pool)
-{
- mempool_destroy(pool->mempool);
- kmem_cache_destroy(pool->slab);
- kfree(pool->name);
-};
-
+ u32 ** sg_ptr);
+extern int i2o_dma_alloc(struct device *dev, struct i2o_dma *addr, size_t len);
+extern void i2o_dma_free(struct device *dev, struct i2o_dma *addr);
+extern int i2o_dma_realloc(struct device *dev, struct i2o_dma *addr,
+ size_t len);
+extern int i2o_pool_alloc(struct i2o_pool *pool, const char *name,
+ size_t size, int min_nr);
+extern void i2o_pool_free(struct i2o_pool *pool);
/* I2O driver (OSM) functions */
extern int i2o_driver_register(struct i2o_driver *);
extern void i2o_driver_unregister(struct i2o_driver *);
projects / linux-2.6-omap-h63xx.git / blobdiff