To compile this driver as a module, choose M here: the
module will be called ehci-hcd.
+choice
+ prompt "PHY/TLL mode"
+ depends on USB_EHCI_HCD && EXPERIMENTAL && ARCH_OMAP34XX
+ ---help---
+ Choose PHY or TLL mode of operation
+
+config OMAP_EHCI_PHY_MODE
+ bool "PHY mode: ISP1504 on Port1/2 (NEW 3430ES2.0)"
+ depends on USB_EHCI_HCD && EXPERIMENTAL && ARCH_OMAP34XX
+ ---help---
+ EHCI PHY mode. Port1 and Port2 are connected to ISP1504 transcievers
+
+config OMAP_EHCI_TLL_MODE
+ bool "TLL mode: (EXPERIMENTAL)"
+ depends on USB_EHCI_HCD && EXPERIMENTAL && ARCH_OMAP34XX
+ ---help---
+ OMAP EHCI controller has TLL mode of operation for all 3 ports.
+ Use this mode when no transciever is present
+endchoice
config USB_EHCI_ROOT_HUB_TT
bool "Root Hub Transaction Translators"
Enables support for the USB controller present on the PowerPC
OpenFirmware platform bus.
+config USB_OXU210HP_HCD
+ tristate "OXU210HP HCD support"
+ depends on USB
+ ---help---
+ The OXU210HP is an USB host/OTG/device controller. Enable this
+ option if your board has this chip. If unsure, say N.
+
+ This driver does not support isochronous transfers and doesn't
+ implement OTG nor USB device controllers.
+
+ To compile this driver as a module, choose M here: the
+ module will be called oxu210hp-hcd.
+
config USB_ISP116X_HCD
tristate "ISP116X HCD support"
depends on USB
tristate "OHCI HCD support"
depends on USB && USB_ARCH_HAS_OHCI
select ISP1301_OMAP if MACH_OMAP_H2 || MACH_OMAP_H3
+ select USB_OTG_UTILS if ARCH_OMAP
---help---
The Open Host Controller Interface (OHCI) is a standard for accessing
USB 1.1 host controller hardware. It does more in hardware than Intel's
To compile this driver as a module, choose M here: the
module will be called uhci-hcd.
+config USB_FHCI_HCD
+ tristate "Freescale QE USB Host Controller support"
+ depends on USB && OF_GPIO && QE_GPIO && QUICC_ENGINE
+ select FSL_GTM
+ select QE_USB
+ help
+ This driver enables support for Freescale QE USB Host Controller
+ (as found on MPC8360 and MPC8323 processors), the driver supports
+ Full and Low Speed USB.
+
+config FHCI_DEBUG
+ bool "Freescale QE USB Host Controller debug support"
+ depends on USB_FHCI_HCD && DEBUG_FS
+ help
+ Say "y" to see some FHCI debug information and statistics
+ throught debugfs.
+
config USB_U132_HCD
tristate "Elan U132 Adapter Host Controller"
depends on USB && USB_FTDI_ELAN