-#include "os_common.h"
+#include "sysdef.h"
#include "wbhal_f.h"
///////////////////////////////////////////////////////////////////////////////////////////////////
// The address is stored in EthernetIDAddr.
//=============================================================================================================
void
-Uxx_ReadEthernetAddress( phw_data_t pHwData )
+Uxx_ReadEthernetAddress( struct hw_data * pHwData )
{
u32 ltmp;
// Return Value:
// None.
//==============================================================================================================
-void CardGetMulticastBit( u8 Address[ETH_LENGTH_OF_ADDRESS],
- u8 *Byte, u8 *Value )
+void CardGetMulticastBit( u8 Address[ETH_ALEN], u8 *Byte, u8 *Value )
{
u32 Crc;
u32 BitNumber;
// First compute the CRC.
- Crc = CardComputeCrc(Address, ETH_LENGTH_OF_ADDRESS);
+ Crc = CardComputeCrc(Address, ETH_ALEN);
// The computed CRC is bit0~31 from left to right
//At first we should do right shift 25bits, and read 7bits by using '&', 2^7=128
*Value = (u8) ((u8)1 << (BitNumber % 8));
}
-void Uxx_power_on_procedure( phw_data_t pHwData )
+void Uxx_power_on_procedure( struct hw_data * pHwData )
{
u32 ltmp, loop;
Wb35Reg_WriteSync( pHwData, 0x03f8, 0x7ff );
}
-void Set_ChanIndep_RfData_al7230_24( phw_data_t pHwData, u32 *pltmp ,char number)
+void Set_ChanIndep_RfData_al7230_24( struct hw_data * pHwData, u32 *pltmp ,char number)
{
u8 i;
}
}
-void Set_ChanIndep_RfData_al7230_50( phw_data_t pHwData, u32 *pltmp, char number)
+void Set_ChanIndep_RfData_al7230_50( struct hw_data * pHwData, u32 *pltmp, char number)
{
u8 i;
// RFSynthesizer_initial --
//=============================================================================================================
void
-RFSynthesizer_initial(phw_data_t pHwData)
+RFSynthesizer_initial(struct hw_data * pHwData)
{
u32 altmp[32];
u32 * pltmp = altmp;
//Start to fill RF parameters, PLL_ON should be pulled low.
Wb35Reg_WriteSync( pHwData, 0x03dc, 0x00000000 );
#ifdef _PE_STATE_DUMP_
- WBDEBUG(("* PLL_ON low\n"));
+ printk("* PLL_ON low\n");
#endif
number = sizeof(al7230_rf_data_24)/sizeof(al7230_rf_data_24[0]);
//pulled high
Wb35Reg_WriteSync( pHwData, 0x03dc, 0x00000080 );
#ifdef _PE_STATE_DUMP_
- WBDEBUG(("* PLL_ON high\n"));
+ printk("* PLL_ON high\n");
#endif
//2.4GHz
//5GHz
Wb35Reg_WriteSync( pHwData, 0x03dc, 0x00000000 );
#ifdef _PE_STATE_DUMP_
- WBDEBUG(("* PLL_ON low\n"));
+ printk("* PLL_ON low\n");
#endif
number = sizeof(al7230_rf_data_50)/sizeof(al7230_rf_data_50[0]);
Wb35Reg_WriteSync( pHwData, 0x03dc, 0x00000080 );
#ifdef _PE_STATE_DUMP_
- WBDEBUG(("* PLL_ON high\n"));
+ printk("* PLL_ON high\n");
#endif
//ltmp = (1 << 31) | (0 << 30) | (24 << 24) | 0x12BACF;
msleep(5);
//Wb35Reg_WriteSync( pHwData, 0x03dc, 0x00000080 );
- //WBDEBUG(("* PLL_ON high\n"));
+ //printk("* PLL_ON high\n");
break;
case RF_WB_242:
}
}
-void BBProcessor_AL7230_2400( phw_data_t pHwData)
+void BBProcessor_AL7230_2400( struct hw_data * pHwData)
{
struct wb35_reg *reg = &pHwData->reg;
u32 pltmp[12];
}
-void BBProcessor_AL7230_5000( phw_data_t pHwData)
+void BBProcessor_AL7230_5000( struct hw_data * pHwData)
{
struct wb35_reg *reg = &pHwData->reg;
u32 pltmp[12];
// None.
//=============================================================================================================
void
-BBProcessor_initial( phw_data_t pHwData )
+BBProcessor_initial( struct hw_data * pHwData )
{
struct wb35_reg *reg = &pHwData->reg;
u32 i, pltmp[12];
reg->SQ3_filter[i] = 0x2f; // half of Bit 0 ~ 6
}
-void set_tx_power_per_channel_max2829( phw_data_t pHwData, ChanInfo Channel)
+void set_tx_power_per_channel_max2829( struct hw_data * pHwData, ChanInfo Channel)
{
RFSynthesizer_SetPowerIndex( pHwData, 100 ); // 20060620.1 Modify
}
-void set_tx_power_per_channel_al2230( phw_data_t pHwData, ChanInfo Channel )
+void set_tx_power_per_channel_al2230( struct hw_data * pHwData, ChanInfo Channel )
{
u8 index = 100;
RFSynthesizer_SetPowerIndex( pHwData, index );
}
-void set_tx_power_per_channel_al7230( phw_data_t pHwData, ChanInfo Channel)
+void set_tx_power_per_channel_al7230( struct hw_data * pHwData, ChanInfo Channel)
{
u8 i, index = 100;
RFSynthesizer_SetPowerIndex( pHwData, index );
}
-void set_tx_power_per_channel_wb242( phw_data_t pHwData, ChanInfo Channel)
+void set_tx_power_per_channel_wb242( struct hw_data * pHwData, ChanInfo Channel)
{
u8 index = 100;
// None.
//=============================================================================================================
void
-RFSynthesizer_SwitchingChannel( phw_data_t pHwData, ChanInfo Channel )
+RFSynthesizer_SwitchingChannel( struct hw_data * pHwData, ChanInfo Channel )
{
struct wb35_reg *reg = &pHwData->reg;
u32 pltmp[16]; // The 16 is the maximum capability of hardware
//Start to fill RF parameters, PLL_ON should be pulled low.
//Wb35Reg_Write( pHwData, 0x03dc, 0x00000000 );
- //WBDEBUG(("* PLL_ON low\n"));
+ //printk("* PLL_ON low\n");
//Channel independent registers
if( Channel.band != pHwData->band)
// Write to register. number must less and equal than 16
Wb35Reg_BurstWrite( pHwData, 0x0864, pltmp, number, NO_INCREMENT );
#ifdef _PE_STATE_DUMP_
- WBDEBUG(("Band changed\n"));
+ printk("Band changed\n");
#endif
}
}
//Set the tx power directly from DUT GUI, not from the EEPROM. Return the current setting
-u8 RFSynthesizer_SetPowerIndex( phw_data_t pHwData, u8 PowerIndex )
+u8 RFSynthesizer_SetPowerIndex( struct hw_data * pHwData, u8 PowerIndex )
{
u32 Band = pHwData->band;
u8 index=0;
}
//-- Sub function
-u8 RFSynthesizer_SetMaxim2828_24Power( phw_data_t pHwData, u8 index )
+u8 RFSynthesizer_SetMaxim2828_24Power( struct hw_data * pHwData, u8 index )
{
u32 PowerData;
if( index > 1 ) index = 1;
return index;
}
//--
-u8 RFSynthesizer_SetMaxim2828_50Power( phw_data_t pHwData, u8 index )
+u8 RFSynthesizer_SetMaxim2828_50Power( struct hw_data * pHwData, u8 index )
{
u32 PowerData;
if( index > 1 ) index = 1;
return index;
}
//--
-u8 RFSynthesizer_SetMaxim2827_24Power( phw_data_t pHwData, u8 index )
+u8 RFSynthesizer_SetMaxim2827_24Power( struct hw_data * pHwData, u8 index )
{
u32 PowerData;
if( index > 1 ) index = 1;
return index;
}
//--
-u8 RFSynthesizer_SetMaxim2827_50Power( phw_data_t pHwData, u8 index )
+u8 RFSynthesizer_SetMaxim2827_50Power( struct hw_data * pHwData, u8 index )
{
u32 PowerData;
if( index > 1 ) index = 1;
return index;
}
//--
-u8 RFSynthesizer_SetMaxim2825Power( phw_data_t pHwData, u8 index )
+u8 RFSynthesizer_SetMaxim2825Power( struct hw_data * pHwData, u8 index )
{
u32 PowerData;
if( index > 1 ) index = 1;
return index;
}
//--
-u8 RFSynthesizer_SetAiroha2230Power( phw_data_t pHwData, u8 index )
+u8 RFSynthesizer_SetAiroha2230Power( struct hw_data * pHwData, u8 index )
{
u32 PowerData;
u8 i,count;
return i;
}
//--
-u8 RFSynthesizer_SetAiroha7230Power( phw_data_t pHwData, u8 index )
+u8 RFSynthesizer_SetAiroha7230Power( struct hw_data * pHwData, u8 index )
{
u32 PowerData;
u8 i,count;
return i;
}
-u8 RFSynthesizer_SetWinbond242Power( phw_data_t pHwData, u8 index )
+u8 RFSynthesizer_SetWinbond242Power( struct hw_data * pHwData, u8 index )
{
u32 PowerData;
u8 i,count;
// Initial the hardware setting and module variable
//
//===========================================================================================================
-void Dxx_initial( phw_data_t pHwData )
+void Dxx_initial( struct hw_data * pHwData )
{
struct wb35_reg *reg = &pHwData->reg;
Wb35Reg_WriteSync( pHwData, 0x0400, reg->D00_DmaControl );
}
-void Mxx_initial( phw_data_t pHwData )
+void Mxx_initial( struct hw_data * pHwData )
{
struct wb35_reg *reg = &pHwData->reg;
u32 tmp;
}
-void Uxx_power_off_procedure( phw_data_t pHwData )
+void Uxx_power_off_procedure( struct hw_data * pHwData )
{
// SW, PMU reset and turn off clock
Wb35Reg_WriteSync( pHwData, 0x03b0, 3 );
}
//Decide the TxVga of every channel
-void GetTxVgaFromEEPROM( phw_data_t pHwData )
+void GetTxVgaFromEEPROM( struct hw_data * pHwData )
{
u32 i, j, ltmp;
u16 Value[MAX_TXVGA_EEPROM];
// or RFSynthesizer_SetPowerIndex be called, new TxVga will take effect.
// TxVgaSettingInEEPROM of sHwData is an u8 array point to EEPROM contain for IS89C35
// This function will use default TxVgaSettingInEEPROM data to calculate new TxVga.
-void EEPROMTxVgaAdjust( phw_data_t pHwData ) // 20060619.5 Add
+void EEPROMTxVgaAdjust( struct hw_data * pHwData ) // 20060619.5 Add
{
u8 * pTxVga = pHwData->TxVgaSettingInEEPROM;
s16 i, stmp;
}
#ifdef _PE_STATE_DUMP_
- WBDEBUG((" TxVgaFor24 : \n"));
+ printk(" TxVgaFor24 : \n");
DataDmp((u8 *)pHwData->TxVgaFor24, 14 ,0);
- WBDEBUG((" TxVgaFor50 : \n"));
+ printk(" TxVgaFor50 : \n");
DataDmp((u8 *)pHwData->TxVgaFor50, 70 ,0);
#endif
}
-void BBProcessor_RateChanging( phw_data_t pHwData, u8 rate ) // 20060613.1
+void BBProcessor_RateChanging( struct hw_data * pHwData, u8 rate ) // 20060613.1
{
struct wb35_reg *reg = &pHwData->reg;
unsigned char Is11bRate;
projects / linux-2.6-omap-h63xx.git / blobdiff