* and irqs should show there too...
*/
#define UWIRE_BASE_PHYS 0xFFFB3000
-#define UWIRE_BASE ((void *__iomem)IO_ADDRESS(UWIRE_BASE_PHYS))
/* uWire Registers: */
#define UWIRE_IO_SIZE 0x20
};
/* REVISIT compile time constant for idx_shift? */
+/*
+ * Or, put it in a structure which is used throughout the driver;
+ * that avoids having to issue two loads for each bit of static data.
+ */
static unsigned int uwire_idx_shift;
+static void __iomem *uwire_base;
static inline void uwire_write_reg(int idx, u16 val)
{
- __raw_writew(val, UWIRE_BASE + (idx << uwire_idx_shift));
+ __raw_writew(val, uwire_base + (idx << uwire_idx_shift));
}
static inline u16 uwire_read_reg(int idx)
{
- return __raw_readw(UWIRE_BASE + (idx << uwire_idx_shift));
+ return __raw_readw(uwire_base + (idx << uwire_idx_shift));
}
static inline void omap_uwire_configure_mode(u8 cs, unsigned long flags)
return -ENODEV;
uwire = spi_master_get_devdata(master);
+
+ uwire_base = ioremap(UWIRE_BASE_PHYS, UWIRE_IO_SIZE);
+ if (!uwire_base) {
+ dev_dbg(&pdev->dev, "can't ioremap UWIRE\n");
+ spi_master_put(master);
+ return -ENOMEM;
+ }
+
dev_set_drvdata(&pdev->dev, uwire);
uwire->ck = clk_get(&pdev->dev, "armxor_ck");
uwire->bitbang.txrx_bufs = uwire_txrx;
status = spi_bitbang_start(&uwire->bitbang);
- if (status < 0)
+ if (status < 0) {
uwire_off(uwire);
+ iounmap(uwire_base);
+ }
return status;
}
status = spi_bitbang_stop(&uwire->bitbang);
uwire_off(uwire);
+ iounmap(uwire_base);
return status;
}