SPI: Add an SPI master driver for the OMAP2 McSPI controller

[linux-2.6-omap-h63xx.git] / drivers / spi / Kconfig

diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index b217a65453f57698710de4ddf3afa782942e38f7..f19e395d758c0b937b44ae4dcd501d8c33386f1d 100644 (file)
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -51,6 +51,13 @@ config SPI_MASTER
 comment "SPI Master Controller Drivers"
        depends on SPI_MASTER
 
+config SPI_ATMEL
+       tristate "Atmel SPI Controller"
+       depends on (ARCH_AT91 || AVR32) && SPI_MASTER
+       help
+         This selects a driver for the Atmel SPI Controller, present on
+         many AT32 (AVR32) and AT91 (ARM) chips.
+
 config SPI_BITBANG
        tristate "Bitbanging SPI master"
        depends on SPI_MASTER && EXPERIMENTAL
@@ -101,6 +108,11 @@ config SPI_OMAP_UWIRE
        help
          This hooks up to the MicroWire controller on OMAP1 chips.
 
+config SPI_OMAP24XX
+       bool "McSPI driver for OMAP24xx"
+       depends on SPI_MASTER && ARCH_OMAP24XX
+       help
+         SPI master controller for OMAP24xx McSPI modules.
 
 config SPI_PXA2XX
        tristate "PXA2xx SSP SPI master"
@@ -135,6 +147,16 @@ config SPI_S3C24XX_GPIO
 comment "SPI Protocol Masters"
        depends on SPI_MASTER
 
+config SPI_AT25
+       tristate "SPI EEPROMs from most vendors"
+       depends on SPI_MASTER && SYSFS
+       help
+         Enable this driver to get read/write support to most SPI EEPROMs,
+         after you configure the board init code to know about each eeprom
+         on your target board.
+
+         This driver can also be built as a module.  If so, the module
+         will be called at25.
 
 #
 # Add new SPI protocol masters in alphabetical order above this line