will be called au1550_spi.
config SPI_BITBANG
- tristate "Bitbanging SPI master"
+ tristate "Utilities for Bitbanging SPI masters"
help
With a few GPIO pins, your system can bitbang the SPI protocol.
Select this to get SPI support through I/O pins (GPIO, parallel
inexpensive battery powered microcontroller evaluation board.
This same cable can be used to flash new firmware.
+config SPI_GPIO
+ tristate "GPIO-based bitbanging SPI Master"
+ depends on GENERIC_GPIO
+ select SPI_BITBANG
+ help
+ This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
+ interface to manage MOSI, MISO, SCK, and chipselect signals. SPI
+ slaves connected to a bus using this driver are configured as usual,
+ except that the spi_board_info.controller_data holds the GPIO number
+ for the chipselect used by this controller driver.
+
+ Note that this driver often won't achieve even 1 Mbit/sec speeds,
+ making it unusually slow for SPI. If your platform can inline
+ GPIO operations, you should be able to leverage that for better
+ speed with a custom version of this driver; see the source code.
+
config SPI_IMX
tristate "Freescale iMX SPI controller"
depends on ARCH_IMX && EXPERIMENTAL
This driver can also be built as a module. If so, the module
will be called at25.
+config SPI_TSC210X
+ depends on SPI_MASTER && EXPERIMENTAL
+ tristate "TI TSC210x (TSC2101/TSC2102) support"
+ help
+ Say Y here if you want support for the TSC210x chips. Some
+ boards use these for touchscreen and audio support.
+
+ These are members of a family of highly integrated PDA analog
+ interface circuit. They include a 12-bit ADC used for battery,
+ temperature, touchscreen, and other sensors. They also have
+ an audio DAC and amplifier, and in some models an audio ADC.
+ The audio support is highly chip-specific, but most of the
+ sensor support works the same.
+
+ Note that the device has to be present in the board's SPI
+ devices table for this driver to load. This driver doesn't
+ automatically enable touchscreen, sensors or audio
+ functionality - enable these in their respective menus.
+
+config SPI_TSC2301
+ tristate "TSC2301 driver"
+ depends on SPI_MASTER
+ help
+ Say Y here if you have a TSC2301 chip connected to an SPI
+ bus on your board.
+
+ The TSC2301 is a highly integrated PDA analog interface circuit.
+ It contains a complete 12-bit A/D resistive touch screen
+ converter (ADC) including drivers, touch pressure measurement
+ capability, keypad controller, and 8-bit D/A converter (DAC) output
+ for LCD contrast control.
+
+ To compile this driver as a module, choose M here: the
+ module will be called tsc2301.
+
+config SPI_TSC2301_AUDIO
+ boolean "TSC2301 audio support"
+ depends on SPI_TSC2301 && SND
+ help
+ Say Y here for if you are using the audio features of TSC2301.
+
config SPI_SPIDEV
tristate "User mode SPI device driver support"
depends on EXPERIMENTAL