/* Attention Button Change */
dbg("shpchp: Attention button interrupt received.\n");
-
+
p_slot = shpchp_find_slot(ctrl, hp_slot + ctrl->slot_device_offset);
p_slot->hpc_ops->get_adapter_status(p_slot, &(p_slot->presence_save));
p_slot = shpchp_find_slot(ctrl, hp_slot + ctrl->slot_device_offset);
- /*
+ /*
* Save the presence state
*/
p_slot->hpc_ops->get_adapter_status(p_slot, &(p_slot->presence_save));
return 1;
}
-/* The following routines constitute the bulk of the
+/* The following routines constitute the bulk of the
hotplug controller logic
*/
static int change_bus_speed(struct controller *ctrl, struct slot *p_slot,
enum pci_bus_speed speed)
-{
+{
int rc = 0;
dbg("%s: change to speed %d\n", __FUNCTION__, speed);
static int fix_bus_speed(struct controller *ctrl, struct slot *pslot,
u8 flag, enum pci_bus_speed asp, enum pci_bus_speed bsp,
enum pci_bus_speed msp)
-{
+{
int rc = 0;
/*
err("%s: Failed to power on slot\n", __FUNCTION__);
return -1;
}
-
+
if ((ctrl->pci_dev->vendor == 0x8086) && (ctrl->pci_dev->device == 0x0332)) {
if (slots_not_empty)
return WRONG_BUS_FREQUENCY;
-
+
if ((rc = p_slot->hpc_ops->set_bus_speed_mode(p_slot, PCI_SPEED_33MHz))) {
err("%s: Issue of set bus speed mode command failed\n", __FUNCTION__);
return WRONG_BUS_FREQUENCY;
}
-
+
/* turn on board, blink green LED, turn off Amber LED */
if ((rc = p_slot->hpc_ops->slot_enable(p_slot))) {
err("%s: Issue of Slot Enable command failed\n", __FUNCTION__);
return rc;
}
}
-
+
rc = p_slot->hpc_ops->get_adapter_speed(p_slot, &asp);
if (rc) {
err("%s: Can't get adapter speed or bus mode mismatch\n",
err("%s: Issue of Slot Disable command failed\n", __FUNCTION__);
return rc;
}
-
+
rc = p_slot->hpc_ops->set_attention_status(p_slot, 0);
if (rc) {
err("%s: Issue of Set Attention command failed\n", __FUNCTION__);