[TG3]: ethtool always report port is TP.

[linux-2.6-omap-h63xx.git] / drivers / net / tg3.c

diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c
index 2bd9592b75cdde117ff50f1df7c2137bd467c808..e1b33a25a25f504e2c246aa326471c0d76c2ea38 100644 (file)
--- a/drivers/net/tg3.c
+++ b/drivers/net/tg3.c
@@ -7653,21 +7653,23 @@ static int tg3_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
                cmd->supported |= (SUPPORTED_1000baseT_Half |
                                   SUPPORTED_1000baseT_Full);
 
-       if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES))
+       if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES)) {
                cmd->supported |= (SUPPORTED_100baseT_Half |
                                  SUPPORTED_100baseT_Full |
                                  SUPPORTED_10baseT_Half |
                                  SUPPORTED_10baseT_Full |
                                  SUPPORTED_MII);
-       else
+               cmd->port = PORT_TP;
+       } else {
                cmd->supported |= SUPPORTED_FIBRE;
+               cmd->port = PORT_FIBRE;
+       }
   
        cmd->advertising = tp->link_config.advertising;
        if (netif_running(dev)) {
                cmd->speed = tp->link_config.active_speed;
                cmd->duplex = tp->link_config.active_duplex;
        }
-       cmd->port = 0;
        cmd->phy_address = PHY_ADDR;
        cmd->transceiver = 0;
        cmd->autoneg = tp->link_config.autoneg;