[netdrvr] ne: Use CONFIG_MACH_TX49XX

[linux-2.6-omap-h63xx.git] / drivers / net / ne.c

diff --git a/drivers/net/ne.c b/drivers/net/ne.c
index 874d291cbaed8447f994f6ac1f4f17d78be122cc..fa3ceca4e15c0c07f3d414b8fbeb05eb711129cb 100644 (file)
--- a/drivers/net/ne.c
+++ b/drivers/net/ne.c
@@ -118,7 +118,7 @@ bad_clone_list[] __initdata = {
     {"E-LAN100", "E-LAN200", {0x00, 0x00, 0x5d}}, /* Broken ne1000 clones */
     {"PCM-4823", "PCM-4823", {0x00, 0xc0, 0x6c}}, /* Broken Advantech MoBo */
     {"REALTEK", "RTL8019", {0x00, 0x00, 0xe8}}, /* no-name with Realtek chip */
-#if defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
+#ifdef CONFIG_MACH_TX49XX
     {"RBHMA4X00-RTL8019", "RBHMA4X00/RTL8019", {0x00, 0x60, 0x0a}},  /* Toshiba built-in */
 #endif
     {"LCS-8834", "LCS-8836", {0x04, 0x04, 0x37}}, /* ShinyNet (SET) */
@@ -142,7 +142,7 @@ bad_clone_list[] __initdata = {
 #if defined(CONFIG_PLAT_MAPPI)
 #  define DCR_VAL 0x4b
 #elif defined(CONFIG_PLAT_OAKS32R)  || \
-   defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
+   defined(CONFIG_MACH_TX49XX)
 #  define DCR_VAL 0x48         /* 8-bit mode */
 #else
 #  define DCR_VAL 0x49
@@ -217,7 +217,7 @@ static int __init do_ne_probe(struct net_device *dev)
 #ifndef MODULE
 struct net_device * __init ne_probe(int unit)
 {
-       struct net_device *dev = alloc_ei_netdev();
+       struct net_device *dev = alloc_eip_netdev();
        int err;
 
        if (!dev)
@@ -355,7 +355,7 @@ static int __init ne_probe1(struct net_device *dev, unsigned long ioaddr)
        }
 
        /* Read the 16 bytes of station address PROM.
-          We must first initialize registers, similar to NS8390_init(eifdev, 0).
+          We must first initialize registers, similar to NS8390p_init(eifdev, 0).
           We can't reliably read the SAPROM address without this.
           (I learned the hard way!). */
        {
@@ -490,7 +490,7 @@ static int __init ne_probe1(struct net_device *dev, unsigned long ioaddr)
 
        /* Snarf the interrupt now.  There's no point in waiting since we cannot
           share and the board will usually be enabled. */
-       ret = request_irq(dev->irq, ei_interrupt, 0, name, dev);
+       ret = request_irq(dev->irq, eip_interrupt, 0, name, dev);
        if (ret) {
                printk (" unable to get IRQ %d (errno=%d).\n", dev->irq, ret);
                goto err_out;
@@ -534,9 +534,9 @@ static int __init ne_probe1(struct net_device *dev, unsigned long ioaddr)
        dev->open = &ne_open;
        dev->stop = &ne_close;
 #ifdef CONFIG_NET_POLL_CONTROLLER
-       dev->poll_controller = ei_poll;
+       dev->poll_controller = eip_poll;
 #endif
-       NS8390_init(dev, 0);
+       NS8390p_init(dev, 0);
 
        ret = register_netdev(dev);
        if (ret)
@@ -554,7 +554,7 @@ err_out:
 
 static int ne_open(struct net_device *dev)
 {
-       ei_open(dev);
+       eip_open(dev);
        return 0;
 }
 
@@ -562,7 +562,7 @@ static int ne_close(struct net_device *dev)
 {
        if (ei_debug > 1)
                printk(KERN_DEBUG "%s: Shutting down ethercard.\n", dev->name);
-       ei_close(dev);
+       eip_close(dev);
        return 0;
 }
 
@@ -794,7 +794,7 @@ retry:
                if (time_after(jiffies, dma_start + 2*HZ/100)) {                /* 20ms */
                        printk(KERN_WARNING "%s: timeout waiting for Tx RDC.\n", dev->name);
                        ne_reset_8390(dev);
-                       NS8390_init(dev,1);
+                       NS8390p_init(dev, 1);
                        break;
                }
 
@@ -814,7 +814,7 @@ static int __init ne_drv_probe(struct platform_device *pdev)
        if (!res || irq < 0)
                return -ENODEV;
 
-       dev = alloc_ei_netdev();
+       dev = alloc_eip_netdev();
        if (!dev)
                return -ENOMEM;
        dev->irq = irq;
@@ -855,7 +855,7 @@ static int ne_drv_resume(struct platform_device *pdev)
 
        if (netif_running(dev)) {
                ne_reset_8390(dev);
-               NS8390_init(dev, 1);
+               NS8390p_init(dev, 1);
                netif_device_attach(dev);
        }
        return 0;
@@ -912,7 +912,7 @@ int __init init_module(void)
        int plat_found = !ne_init();
 
        for (this_dev = 0; this_dev < MAX_NE_CARDS; this_dev++) {
-               struct net_device *dev = alloc_ei_netdev();
+               struct net_device *dev = alloc_eip_netdev();
                if (!dev)
                        break;
                dev->irq = irq[this_dev];