* 82567LM-2 Gigabit Network Connection
* 82567LF-2 Gigabit Network Connection
* 82567V-2 Gigabit Network Connection
- * 82562GT-3 10/100 Network Connection
+ * 82567LF-3 Gigabit Network Connection
+ * 82567LM-3 Gigabit Network Connection
+ * 82567LM-4 Gigabit Network Connection
*/
#include <linux/netdevice.h>
static s32 e1000_erase_flash_bank_ich8lan(struct e1000_hw *hw, u32 bank);
static s32 e1000_retry_write_flash_byte_ich8lan(struct e1000_hw *hw,
u32 offset, u8 byte);
+static s32 e1000_read_flash_byte_ich8lan(struct e1000_hw *hw, u32 offset,
+ u8 *data);
static s32 e1000_read_flash_word_ich8lan(struct e1000_hw *hw, u32 offset,
u16 *data);
static s32 e1000_read_flash_data_ich8lan(struct e1000_hw *hw, u32 offset,
u8 size, u16 *data);
static s32 e1000_setup_copper_link_ich8lan(struct e1000_hw *hw);
static s32 e1000_kmrn_lock_loss_workaround_ich8lan(struct e1000_hw *hw);
+static s32 e1000_get_cfg_done_ich8lan(struct e1000_hw *hw);
static inline u16 __er16flash(struct e1000_hw *hw, unsigned long reg)
{
if (!timeout) {
hw_dbg(hw, "FW or HW has locked the resource for too long.\n");
+ extcnf_ctrl &= ~E1000_EXTCNF_CTRL_SWFLAG;
+ ew32(EXTCNF_CTRL, extcnf_ctrl);
nvm_owner = -1;
mutex_unlock(&nvm_mutex);
return -E1000_ERR_CONFIG;
mutex_unlock(&nvm_mutex);
}
+/**
+ * e1000_check_mng_mode_ich8lan - Checks management mode
+ * @hw: pointer to the HW structure
+ *
+ * This checks if the adapter has manageability enabled.
+ * This is a function pointer entry point only called by read/write
+ * routines for the PHY and NVM parts.
+ **/
+static bool e1000_check_mng_mode_ich8lan(struct e1000_hw *hw)
+{
+ u32 fwsm = er32(FWSM);
+
+ return (fwsm & E1000_FWSM_MODE_MASK) ==
+ (E1000_ICH_MNG_IAMT_MODE << E1000_FWSM_MODE_SHIFT);
+}
+
/**
* e1000_check_reset_block_ich8lan - Check if PHY reset is blocked
* @hw: pointer to the HW structure
return 0;
}
+/**
+ * e1000_valid_nvm_bank_detect_ich8lan - finds out the valid bank 0 or 1
+ * @hw: pointer to the HW structure
+ * @bank: pointer to the variable that returns the active bank
+ *
+ * Reads signature byte from the NVM using the flash access registers.
+ **/
+static s32 e1000_valid_nvm_bank_detect_ich8lan(struct e1000_hw *hw, u32 *bank)
+{
+ struct e1000_nvm_info *nvm = &hw->nvm;
+ /* flash bank size is in words */
+ u32 bank1_offset = nvm->flash_bank_size * sizeof(u16);
+ u32 act_offset = E1000_ICH_NVM_SIG_WORD * 2 + 1;
+ u8 bank_high_byte = 0;
+
+ if (hw->mac.type != e1000_ich10lan) {
+ if (er32(EECD) & E1000_EECD_SEC1VAL)
+ *bank = 1;
+ else
+ *bank = 0;
+ } else {
+ /*
+ * Make sure the signature for bank 0 is valid,
+ * if not check for bank1
+ */
+ e1000_read_flash_byte_ich8lan(hw, act_offset, &bank_high_byte);
+ if ((bank_high_byte & 0xC0) == 0x80) {
+ *bank = 0;
+ } else {
+ /*
+ * find if segment 1 is valid by verifying
+ * bit 15:14 = 10b in word 0x13
+ */
+ e1000_read_flash_byte_ich8lan(hw,
+ act_offset + bank1_offset,
+ &bank_high_byte);
+
+ /* bank1 has a valid signature equivalent to SEC1V */
+ if ((bank_high_byte & 0xC0) == 0x80) {
+ *bank = 1;
+ } else {
+ hw_dbg(hw, "ERROR: EEPROM not present\n");
+ return -E1000_ERR_NVM;
+ }
+ }
+ }
+
+ return 0;
+}
+
/**
* e1000_read_nvm_ich8lan - Read word(s) from the NVM
* @hw: pointer to the HW structure
struct e1000_dev_spec_ich8lan *dev_spec = &hw->dev_spec.ich8lan;
u32 act_offset;
s32 ret_val;
+ u32 bank = 0;
u16 i, word;
if ((offset >= nvm->word_size) || (words > nvm->word_size - offset) ||
if (ret_val)
return ret_val;
- /* Start with the bank offset, then add the relative offset. */
- act_offset = (er32(EECD) & E1000_EECD_SEC1VAL)
- ? nvm->flash_bank_size
- : 0;
+ ret_val = e1000_valid_nvm_bank_detect_ich8lan(hw, &bank);
+ if (ret_val)
+ return ret_val;
+
+ act_offset = (bank) ? nvm->flash_bank_size : 0;
act_offset += offset;
for (i = 0; i < words; i++) {
return e1000_read_flash_data_ich8lan(hw, offset, 2, data);
}
+/**
+ * e1000_read_flash_byte_ich8lan - Read byte from flash
+ * @hw: pointer to the HW structure
+ * @offset: The offset of the byte to read.
+ * @data: Pointer to a byte to store the value read.
+ *
+ * Reads a single byte from the NVM using the flash access registers.
+ **/
+static s32 e1000_read_flash_byte_ich8lan(struct e1000_hw *hw, u32 offset,
+ u8 *data)
+{
+ s32 ret_val;
+ u16 word = 0;
+
+ ret_val = e1000_read_flash_data_ich8lan(hw, offset, 1, &word);
+ if (ret_val)
+ return ret_val;
+
+ *data = (u8)word;
+
+ return 0;
+}
+
/**
* e1000_read_flash_data_ich8lan - Read byte or word from NVM
* @hw: pointer to the HW structure
{
struct e1000_nvm_info *nvm = &hw->nvm;
struct e1000_dev_spec_ich8lan *dev_spec = &hw->dev_spec.ich8lan;
- u32 i, act_offset, new_bank_offset, old_bank_offset;
+ u32 i, act_offset, new_bank_offset, old_bank_offset, bank;
s32 ret_val;
u16 data;
* write to bank 0 etc. We also need to erase the segment that
* is going to be written
*/
- if (!(er32(EECD) & E1000_EECD_SEC1VAL)) {
+ ret_val = e1000_valid_nvm_bank_detect_ich8lan(hw, &bank);
+ if (ret_val)
+ return ret_val;
+
+ if (bank == 0) {
new_bank_offset = nvm->flash_bank_size;
old_bank_offset = 0;
e1000_erase_flash_bank_ich8lan(hw, 1);
ctrl |= E1000_CTRL_PHY_RST;
}
ret_val = e1000_acquire_swflag_ich8lan(hw);
+ /* Whether or not the swflag was acquired, we need to reset the part */
hw_dbg(hw, "Issuing a global reset to ich8lan");
ew32(CTRL, (ctrl | E1000_CTRL_RST));
msleep(20);
- /* release the swflag because it is not reset by hardware reset */
- e1000_release_swflag_ich8lan(hw);
+ if (!ret_val) {
+ /* release the swflag because it is not reset by
+ * hardware reset
+ */
+ e1000_release_swflag_ich8lan(hw);
+ }
ret_val = e1000e_get_auto_rd_done(hw);
if (ret_val) {
* 'LPLU Enabled' and 'Gig Disable' to force link speed negotiation
* to a lower speed.
*
- * Should only be called for ICH9 devices.
+ * Should only be called for ICH9 and ICH10 devices.
**/
void e1000e_disable_gig_wol_ich8lan(struct e1000_hw *hw)
{
u32 phy_ctrl;
- if (hw->mac.type == e1000_ich9lan) {
+ if ((hw->mac.type == e1000_ich10lan) ||
+ (hw->mac.type == e1000_ich9lan)) {
phy_ctrl = er32(PHY_CTRL);
phy_ctrl |= E1000_PHY_CTRL_D0A_LPLU |
E1000_PHY_CTRL_GBE_DISABLE;
return 0;
}
+/**
+ * e1000_get_cfg_done_ich8lan - Read config done bit
+ * @hw: pointer to the HW structure
+ *
+ * Read the management control register for the config done bit for
+ * completion status. NOTE: silicon which is EEPROM-less will fail trying
+ * to read the config done bit, so an error is *ONLY* logged and returns
+ * E1000_SUCCESS. If we were to return with error, EEPROM-less silicon
+ * would not be able to be reset or change link.
+ **/
+static s32 e1000_get_cfg_done_ich8lan(struct e1000_hw *hw)
+{
+ u32 bank = 0;
+
+ e1000e_get_cfg_done(hw);
+
+ /* If EEPROM is not marked present, init the IGP 3 PHY manually */
+ if (hw->mac.type != e1000_ich10lan) {
+ if (((er32(EECD) & E1000_EECD_PRES) == 0) &&
+ (hw->phy.type == e1000_phy_igp_3)) {
+ e1000e_phy_init_script_igp3(hw);
+ }
+ } else {
+ if (e1000_valid_nvm_bank_detect_ich8lan(hw, &bank)) {
+ /* Maybe we should do a basic PHY config */
+ hw_dbg(hw, "EEPROM not present\n");
+ return -E1000_ERR_CONFIG;
+ }
+ }
+
+ return 0;
+}
+
/**
* e1000_clear_hw_cntrs_ich8lan - Clear statistical counters
* @hw: pointer to the HW structure
}
static struct e1000_mac_operations ich8_mac_ops = {
- .mng_mode_enab = E1000_ICH_MNG_IAMT_MODE << E1000_FWSM_MODE_SHIFT,
+ .check_mng_mode = e1000_check_mng_mode_ich8lan,
.check_for_link = e1000e_check_for_copper_link,
.cleanup_led = e1000_cleanup_led_ich8lan,
.clear_hw_cntrs = e1000_clear_hw_cntrs_ich8lan,
.check_reset_block = e1000_check_reset_block_ich8lan,
.commit_phy = NULL,
.force_speed_duplex = e1000_phy_force_speed_duplex_ich8lan,
- .get_cfg_done = e1000e_get_cfg_done,
+ .get_cfg_done = e1000_get_cfg_done_ich8lan,
.get_cable_length = e1000e_get_cable_length_igp_2,
.get_phy_info = e1000_get_phy_info_ich8lan,
.read_phy_reg = e1000e_read_phy_reg_igp,
.nvm_ops = &ich8_nvm_ops,
};
+struct e1000_info e1000_ich10_info = {
+ .mac = e1000_ich10lan,
+ .flags = FLAG_HAS_JUMBO_FRAMES
+ | FLAG_IS_ICH
+ | FLAG_HAS_WOL
+ | FLAG_RX_CSUM_ENABLED
+ | FLAG_HAS_CTRLEXT_ON_LOAD
+ | FLAG_HAS_AMT
+ | FLAG_HAS_ERT
+ | FLAG_HAS_FLASH
+ | FLAG_APME_IN_WUC,
+ .pba = 10,
+ .get_variants = e1000_get_variants_ich8lan,
+ .mac_ops = &ich8_mac_ops,
+ .phy_ops = &ich8_phy_ops,
+ .nvm_ops = &ich8_nvm_ops,
+};
projects / linux-2.6-omap-h63xx.git / blobdiff