bnx2x: Add support for BCM57711 HW

[linux-2.6-omap-h63xx.git] / drivers / net / bnx2x_link.c

diff --git a/drivers/net/bnx2x_link.c b/drivers/net/bnx2x_link.c
index 22586ebd7b1e0793fadfce6414d4ff35055247d0..ff2743db10d9ef69081a0d96762fcefe96d2de51 100644 (file)
--- a/drivers/net/bnx2x_link.c
+++ b/drivers/net/bnx2x_link.c
@@ -3572,7 +3572,8 @@ u8 bnx2x_set_led(struct bnx2x *bp, u8 port, u8 mode, u32 speed,
                           LED_BLINK_RATE_VAL);
                REG_WR(bp, NIG_REG_LED_CONTROL_BLINK_RATE_ENA_P0 +
                           port*4, 1);
-               if (((speed == SPEED_2500) ||
+               if (!CHIP_IS_E1H(bp) &&
+                   ((speed == SPEED_2500) ||
                     (speed == SPEED_1000) ||
                     (speed == SPEED_100) ||
                     (speed == SPEED_10))) {
@@ -3753,6 +3754,14 @@ u8 bnx2x_phy_init(struct link_params *params, struct link_vars *vars)
                vars->duplex = DUPLEX_FULL;
                vars->flow_ctrl = FLOW_CTRL_NONE;
                vars->link_status = (LINK_STATUS_LINK_UP | LINK_10GTFD);
+               /* enable on E1.5 FPGA */
+               if (CHIP_IS_E1H(bp)) {
+                       vars->flow_ctrl |=
+                               (FLOW_CTRL_TX | FLOW_CTRL_RX);
+                       vars->link_status |=
+                                       (LINK_STATUS_TX_FLOW_CONTROL_ENABLED |
+                                        LINK_STATUS_RX_FLOW_CONTROL_ENABLED);
+               }
 
                bnx2x_emac_enable(params, vars, 0);
                bnx2x_pbf_update(params, vars->flow_ctrl, vars->line_speed);