Annapolis MD 21403
Fixed (again!) the missing interrupt locking on TX/RX shifting.
- Alan Cox <Alan.Cox@linux.org>
+ Alan Cox <alan@lxorguk.ukuu.org.uk>
Removed calls to init_etherdev since they are no longer needed, and
cleaned up modularization just a bit. The driver still allows only
the board. Now getting 150K/second FTP with a 3c501 card. Still playing
with a TX-TX optimisation to see if we can touch 180-200K/second as seems
theoretically maximum.
- 19950402 Alan Cox <Alan.Cox@linux.org>
+ 19950402 Alan Cox <alan@lxorguk.ukuu.org.uk>
Cleaned up for 2.3.x because we broke SMP now.
- 20000208 Alan Cox <alan@redhat.com>
+ 20000208 Alan Cox <alan@lxorguk.ukuu.org.uk>
Check up pass for 2.5. Nothing significant changed
- 20021009 Alan Cox <alan@redhat.com>
+ 20021009 Alan Cox <alan@lxorguk.ukuu.org.uk>
Fixed zero fill corner case
- 20030104 Alan Cox <alan@redhat.com>
+ 20030104 Alan Cox <alan@lxorguk.ukuu.org.uk>
For the avoidance of doubt the "preferred form" of this code is one which
static const char version[] =
- DRV_NAME ".c: " DRV_VERSION " Alan Cox (alan@redhat.com).\n";
+ DRV_NAME ".c: " DRV_VERSION " Alan Cox (alan@lxorguk.ukuu.org.uk).\n";
/*
* Braindamage remaining:
printk(KERN_DEBUG "%s: burped during tx load.\n",
dev->name);
spin_lock_irqsave(&lp->lock, flags);
- }
- while (1);
-
+ } while (1);
}
/**
dev->stats.tx_packets++;
if (el_debug > 6)
printk(KERN_DEBUG " Tx succeeded %s\n",
- (txsr & TX_RDY) ? "." : "but tx is busy!");
+ (txsr & TX_RDY) ? "." :
+ "but tx is busy!");
/*
* This is safe the interrupt is atomic WRT itself.
*/
if (pkt_len < 60 || pkt_len > 1536) {
if (el_debug)
- printk(KERN_DEBUG "%s: bogus packet, length=%d\n", dev->name, pkt_len);
+ printk(KERN_DEBUG "%s: bogus packet, length=%d\n",
+ dev->name, pkt_len);
dev->stats.rx_over_errors++;
return;
}
outw(0x00, GP_LOW);
if (skb == NULL) {
- printk(KERN_INFO "%s: Memory squeeze, dropping packet.\n", dev->name);
+ printk(KERN_INFO "%s: Memory squeeze, dropping packet.\n",
+ dev->name);
dev->stats.rx_dropped++;
return;
} else {
if (el_debug > 2)
printk(KERN_INFO "3c501 reset...");
outb(AX_RESET, AX_CMD); /* Reset the chip */
- outb(AX_LOOP, AX_CMD); /* Aux control, irq and loopback enabled */
+ /* Aux control, irq and loopback enabled */
+ outb(AX_LOOP, AX_CMD);
{
int i;
for (i = 0; i < 6; i++) /* Set the station address. */