]> www.pilppa.org Git - linux-2.6-omap-h63xx.git/blobdiff - drivers/mtd/nand/Kconfig
Merge current mainline tree into linux-omap tree
[linux-2.6-omap-h63xx.git] / drivers / mtd / nand / Kconfig
index 295a56876cb1b8c82912dd546fc9bdba22c13796..4ac8c0f90184ab6abbce30d6c7a52da447352811 100644 (file)
@@ -104,6 +104,25 @@ config MTD_NAND_AU1550
          This enables the driver for the NAND flash controller on the
          AMD/Alchemy 1550 SOC.
 
+config MTD_NAND_BF5XX
+       tristate "Blackfin on-chip NAND Flash Controller driver"
+       depends on BF54x && MTD_NAND
+       help
+         This enables the Blackfin on-chip NAND flash controller
+
+         No board specific support is done by this driver, each board
+         must advertise a platform_device for the driver to attach.
+
+         This driver can also be built as a module. If so, the module
+         will be called bf5xx-nand.
+
+config MTD_NAND_BF5XX_HWECC
+       bool "BF5XX NAND Hardware ECC"
+       depends on MTD_NAND_BF5XX
+       help
+         Enable the use of the BF5XX's internal ECC generator when
+         using NAND.
+
 config MTD_NAND_RTC_FROM4
        tristate "Renesas Flash ROM 4-slot interface board (FROM_BOARD4)"
        depends on SH_SOLUTION_ENGINE
@@ -147,10 +166,10 @@ config MTD_NAND_S3C2410_HWECC
 
 config MTD_NAND_NDFC
        tristate "NDFC NanD Flash Controller"
-       depends on 44x
+       depends on 4xx && !PPC_MERGE
        select MTD_NAND_ECC_SMC
        help
-        NDFC Nand Flash Controllers are integrated in EP44x SoCs
+        NDFC Nand Flash Controllers are integrated in IBM/AMCC's 4xx SoCs
 
 config MTD_NAND_S3C2410_CLKSTOP
        bool "S3C2410 NAND IDLE clock stop"
@@ -250,7 +269,7 @@ config MTD_NAND_CAFE
        select REED_SOLOMON
        select REED_SOLOMON_DEC16
        help
-         Use NAND flash attached to the CAFÉ chip designed for the $100
+         Use NAND flash attached to the CAFÉ chip designed for the OLPC
          laptop.
 
 config MTD_NAND_CS553X
@@ -293,5 +312,11 @@ config MTD_NAND_PLATFORM
          devices. You will need to provide platform-specific functions
          via platform_data.
 
+config MTD_ALAUDA
+       tristate "MTD driver for Olympus MAUSB-10 and Fujifilm DPC-R1"
+       depends on MTD_NAND && USB
+       help
+         These two (and possibly other) Alauda-based cardreaders for
+         SmartMedia and xD allow raw flash access.
 
 endif # MTD_NAND