# drivers/mtd/maps/Kconfig
-# $Id: Kconfig,v 1.61 2005/11/07 11:14:26 gleixner Exp $
menu "Mapping drivers for chip access"
depends on MTD!=n
help
Flash memory access on AMD Alchemy Pb/Db/RDK Reference Boards
-config MTD_MTX1
- tristate "4G Systems MTX-1 Flash device"
- depends on MIPS_MTX1 && MTD_CFI
- help
- Flash memory access on 4G Systems MTX-1 Board. If you have one of
- these boards and would like to use the flash chips on it, say 'Y'.
-
config MTD_DILNETPC
tristate "CFI Flash device mapped on DIL/Net PC"
depends on X86 && MTD_CONCAT && MTD_PARTITIONS && MTD_CFI_INTELEXT
config MTD_SOLUTIONENGINE
tristate "CFI Flash device mapped on Hitachi SolutionEngine"
- depends on SUPERH && MTD_CFI && MTD_REDBOOT_PARTS
+ depends on SUPERH && SOLUTION_ENGINE && MTD_CFI && MTD_REDBOOT_PARTS
help
This enables access to the flash chips on the Hitachi SolutionEngine and
similar boards. Say 'Y' if you are building a kernel for such a board.
This enables access to the flash chips on the Hynix evaluation boards.
If you have such a board, say 'Y'.
-config MTD_MPC1211
- tristate "CFI Flash device mapped on Interface MPC-1211"
- depends on SH_MPC1211 && MTD_CFI
- help
- This enables access to the flash chips on the Interface MPC-1211(CTP/PCI/MPC-SH02).
- If you have such a board, say 'Y'.
-
config MTD_OMAP_NOR
tristate "TI OMAP board mappings"
depends on MTD_CFI && ARCH_OMAP
If unsure, say N.
+config MTD_BFIN_ASYNC
+ tristate "Blackfin BF533-STAMP Flash Chip Support"
+ depends on BFIN533_STAMP && MTD_CFI
+ select MTD_PARTITIONS
+ default y
+ help
+ Map driver which allows for simultaneous utilization of
+ ethernet and CFI parallel flash.
+
+ If compiled as a module, it will be called bfin-async-flash.
+
config MTD_UCLINUX
tristate "Generic uClinux RAM/ROM filesystem support"
depends on MTD_PARTITIONS && !MMU
help
Map driver for Dy-4 SVME/DMV-182 board.
-config MTD_BAST
- tristate "Map driver for Simtec BAST (EB2410ITX) or Thorcom VR1000"
- depends on ARCH_BAST || MACH_VR1000
- select MTD_PARTITIONS
- select MTD_MAP_BANK_WIDTH_16
- select MTD_JEDECPROBE
- help
- Map driver for NOR flash on the Simtec BAST (EB2410ITX), or the
- Thorcom VR1000
-
- Note, this driver *cannot* over-ride the WP link on the
- board, or currently detect the state of the link.
-
-config MTD_BAST_MAXSIZE
- int "Maximum size for BAST flash area (MiB)"
- depends on MTD_BAST
- default "4"
-
config MTD_SHARP_SL
tristate "ROM mapped on Sharp SL Series"
depends on ARCH_PXA