[MTD] physmap: make physmap compat explicit

[linux-2.6-omap-h63xx.git] / drivers / mtd / maps / Kconfig

diff --git a/drivers/mtd/maps/Kconfig b/drivers/mtd/maps/Kconfig
index 5ea1693621642b84fbcbe482202395d493b0a91b..3788a548336c99c5a1f4b49fc28380ed3280fa66 100644 (file)
--- a/drivers/mtd/maps/Kconfig
+++ b/drivers/mtd/maps/Kconfig
@@ -23,9 +23,20 @@ config MTD_PHYSMAP
          To compile this driver as a module, choose M here: the
          module will be called physmap.
 
+config MTD_PHYSMAP_COMPAT
+       bool "Physmap compat support"
+       depends on MTD_PHYSMAP
+       default n
+       help
+         Setup a simple mapping via the Kconfig options.  Normally the
+         physmap configuration options are done via your board's
+         resource file.
+
+         If unsure, say N here.
+
 config MTD_PHYSMAP_START
        hex "Physical start address of flash mapping"
-       depends on MTD_PHYSMAP
+       depends on MTD_PHYSMAP_COMPAT
        default "0x8000000"
        help
          This is the physical memory location at which the flash chips
@@ -37,7 +48,7 @@ config MTD_PHYSMAP_START
 
 config MTD_PHYSMAP_LEN
        hex "Physical length of flash mapping"
-       depends on MTD_PHYSMAP
+       depends on MTD_PHYSMAP_COMPAT
        default "0"
        help
          This is the total length of the mapping of the flash chips on
@@ -51,7 +62,7 @@ config MTD_PHYSMAP_LEN
 
 config MTD_PHYSMAP_BANKWIDTH
        int "Bank width in octets"
-       depends on MTD_PHYSMAP
+       depends on MTD_PHYSMAP_COMPAT
        default "2"
        help
          This is the total width of the data bus of the flash devices