* Note: for more information, please refer "AMD Alchemy Au1200/Au1550 IDE
* Interface and Linux Device Driver" Application Note.
*/
-#undef REALLY_SLOW_IO /* most systems can safely undef this */
-
#include <linux/types.h>
#include <linux/module.h>
#include <linux/kernel.h>
{
int mem_sttime;
int mem_stcfg;
- unsigned long mode;
-
-#ifdef CONFIG_BLK_DEV_IDE_AU1XXX_MDMA2_DBDMA
- if (ide_use_dma(drive))
- mode = ide_dma_speed(drive, 0);
-#endif
mem_sttime = 0;
mem_stcfg = au_readl(MEM_STCFG2);
auide_tune_drive(drive, speed - XFER_PIO_0);
return 0;
}
-
+
switch(speed) {
#ifdef CONFIG_BLK_DEV_IDE_AU1XXX_MDMA2_DBDMA
case XFER_MW_DMA_2:
mem_stcfg &= ~TOECS_MASK;
mem_stcfg |= SBC_IDE_MDMA2_TCSOE | SBC_IDE_MDMA2_TOECS;
- mode = XFER_MW_DMA_2;
break;
case XFER_MW_DMA_1:
mem_sttime = SBC_IDE_TIMING(MDMA1);
mem_stcfg &= ~TOECS_MASK;
mem_stcfg |= SBC_IDE_MDMA1_TCSOE | SBC_IDE_MDMA1_TOECS;
- mode = XFER_MW_DMA_1;
break;
case XFER_MW_DMA_0:
mem_sttime = SBC_IDE_TIMING(MDMA0);
mem_stcfg &= ~TOECS_MASK;
mem_stcfg |= SBC_IDE_MDMA0_TCSOE | SBC_IDE_MDMA0_TOECS;
- mode = XFER_MW_DMA_0;
break;
#endif
default:
return 1;
}
-
- if (ide_config_drive_speed(drive, mode))
+
+ if (ide_config_drive_speed(drive, speed))
return 1;
au_writel(mem_sttime,MEM_STTIME2);
speed = ide_find_best_mode(drive, XFER_PIO | XFER_MWDMA);
if (drive->autodma && (speed & XFER_MODE) != XFER_PIO)
- return HWIF(drive)->ide_dma_on(drive);
+ return 0;
- return HWIF(drive)->ide_dma_off_quietly(drive);
+ return -1;
}
static int auide_dma_test_irq(ide_drive_t *drive)
return 0;
}
-static int auide_dma_host_on(ide_drive_t *drive)
+static void auide_dma_host_on(ide_drive_t *drive)
{
- return 0;
}
static int auide_dma_on(ide_drive_t *drive)
{
drive->using_dma = 1;
- return auide_dma_host_on(drive);
-}
+ return 0;
+}
-static int auide_dma_host_off(ide_drive_t *drive)
+static void auide_dma_host_off(ide_drive_t *drive)
{
- return 0;
}
-static int auide_dma_off_quietly(ide_drive_t *drive)
+static void auide_dma_off_quietly(ide_drive_t *drive)
{
drive->using_dma = 0;
- return auide_dma_host_off(drive);
}
-static int auide_dma_lostirq(ide_drive_t *drive)
+static void auide_dma_lost_irq(ide_drive_t *drive)
{
printk(KERN_ERR "%s: IRQ lost\n", drive->name);
- return 0;
}
static void auide_ddma_tx_callback(int irq, void *param)
#if defined(CONFIG_BLK_DEV_IDE_AU1XXX_MDMA2_DBDMA)
-static int auide_dma_timeout(ide_drive_t *drive)
+static void auide_dma_timeout(ide_drive_t *drive)
{
-// printk("%s\n", __FUNCTION__);
+ ide_hwif_t *hwif = HWIF(drive);
printk(KERN_ERR "%s: DMA timeout occurred: ", drive->name);
- if (HWIF(drive)->ide_dma_test_irq(drive))
- return 0;
+ if (hwif->ide_dma_test_irq(drive))
+ return;
- return HWIF(drive)->ide_dma_end(drive);
+ hwif->ide_dma_end(drive);
}
_auide_hwif *ahwif = &auide_hwif;
ide_hwif_t *hwif;
struct resource *res;
+ hw_regs_t *hw;
int ret = 0;
#if defined(CONFIG_BLK_DEV_IDE_AU1XXX_MDMA2_DBDMA)
/* FIXME: This might possibly break PCMCIA IDE devices */
hwif = &ide_hwifs[pdev->id];
- hw_regs_t *hw = &hwif->hw;
+ hw = &hwif->hw;
hwif->irq = hw->irq = ahwif->irq;
hwif->chipset = ide_au1xxx;
/* hold should be on in all cases */
hwif->hold = 1;
- hwif->mmio = 2;
+
+ hwif->mmio = 1;
/* If the user has selected DDMA assisted copies,
then set up a few local I/O function entry points
hwif->speedproc = &auide_tune_chipset;
#ifdef CONFIG_BLK_DEV_IDE_AU1XXX_MDMA2_DBDMA
- hwif->ide_dma_off_quietly = &auide_dma_off_quietly;
- hwif->ide_dma_timeout = &auide_dma_timeout;
+ hwif->dma_off_quietly = &auide_dma_off_quietly;
+ hwif->dma_timeout = &auide_dma_timeout;
hwif->ide_dma_check = &auide_dma_check;
hwif->dma_exec_cmd = &auide_dma_exec_cmd;
hwif->ide_dma_end = &auide_dma_end;
hwif->dma_setup = &auide_dma_setup;
hwif->ide_dma_test_irq = &auide_dma_test_irq;
- hwif->ide_dma_host_off = &auide_dma_host_off;
- hwif->ide_dma_host_on = &auide_dma_host_on;
- hwif->ide_dma_lostirq = &auide_dma_lostirq;
+ hwif->dma_host_off = &auide_dma_host_off;
+ hwif->dma_host_on = &auide_dma_host_on;
+ hwif->dma_lost_irq = &auide_dma_lost_irq;
hwif->ide_dma_on = &auide_dma_on;
hwif->autodma = 1;
#endif
probe_hwif_init(hwif);
+
+ ide_proc_register_port(hwif);
+
dev_set_drvdata(dev, hwif);
printk(KERN_INFO "Au1xxx IDE(builtin) configured for %s\n", mode );