* (usually 14 & 15).
* There can be up to two drives per interface, as per the ATA-2 spec.
*
- * Primary: ide0, port 0x1f0; major=3; hda is minor=0; hdb is minor=64
- * Secondary: ide1, port 0x170; major=22; hdc is minor=0; hdd is minor=64
- * Tertiary: ide2, port 0x???; major=33; hde is minor=0; hdf is minor=64
- * Quaternary: ide3, port 0x???; major=34; hdg is minor=0; hdh is minor=64
* ...
*
* From hd.c:
* This was a rewrite of just about everything from hd.c, though some original
* code is still sprinkled about. Think of it as a major evolution, with
* inspiration from lots of linux users, esp. hamish@zot.apana.org.au
- *
- * Version 1.0 ALPHA initial code, primary i/f working okay
- * Version 1.3 BETA dual i/f on shared irq tested & working!
- * Version 1.4 BETA added auto probing for irq(s)
- * Version 1.5 BETA added ALPHA (untested) support for IDE cd-roms,
- * ...
- * Version 5.50 allow values as small as 20 for idebus=
- * Version 5.51 force non io_32bit in drive_cmd_intr()
- * change delay_10ms() to delay_50ms() to fix problems
- * Version 5.52 fix incorrect invalidation of removable devices
- * add "hdx=slow" command line option
- * Version 5.60 start to modularize the driver; the disk and ATAPI
- * drivers can be compiled as loadable modules.
- * move IDE probe code to ide-probe.c
- * move IDE disk code to ide-disk.c
- * add support for generic IDE device subdrivers
- * add m68k code from Geert Uytterhoeven
- * probe all interfaces by default
- * add ioctl to (re)probe an interface
- * Version 6.00 use per device request queues
- * attempt to optimize shared hwgroup performance
- * add ioctl to manually adjust bandwidth algorithms
- * add kerneld support for the probe module
- * fix bug in ide_error()
- * fix bug in the first ide_get_lock() call for Atari
- * don't flush leftover data for ATAPI devices
- * Version 6.01 clear hwgroup->active while the hwgroup sleeps
- * support HDIO_GETGEO for floppies
- * Version 6.02 fix ide_ack_intr() call
- * check partition table on floppies
- * Version 6.03 handle bad status bit sequencing in ide_wait_stat()
- * Version 6.10 deleted old entries from this list of updates
- * replaced triton.c with ide-dma.c generic PCI DMA
- * added support for BIOS-enabled UltraDMA
- * rename all "promise" things to "pdc4030"
- * fix EZ-DRIVE handling on small disks
- * Version 6.11 fix probe error in ide_scan_devices()
- * fix ancient "jiffies" polling bugs
- * mask all hwgroup interrupts on each irq entry
- * Version 6.12 integrate ioctl and proc interfaces
- * fix parsing of "idex=" command line parameter
- * Version 6.13 add support for ide4/ide5 courtesy rjones@orchestream.com
- * Version 6.14 fixed IRQ sharing among PCI devices
- * Version 6.15 added SMP awareness to IDE drivers
- * Version 6.16 fixed various bugs; even more SMP friendly
- * Version 6.17 fix for newest EZ-Drive problem
- * Version 6.18 default unpartitioned-disk translation now "BIOS LBA"
- * Version 6.19 Re-design for a UNIFORM driver for all platforms,
- * model based on suggestions from Russell King and
- * Geert Uytterhoeven
- * Promise DC4030VL now supported.
- * add support for ide6/ide7
- * delay_50ms() changed to ide_delay_50ms() and exported.
- * Version 6.20 Added/Fixed Generic ATA-66 support and hwif detection.
- * Added hdx=flash to allow for second flash disk
- * detection w/o the hang loop.
- * Added support for ide8/ide9
- * Added idex=ata66 for the quirky chipsets that are
- * ATA-66 compliant, but have yet to determine a method
- * of verification of the 80c cable presence.
- * Specifically Promise's PDC20262 chipset.
- * Version 6.21 Fixing/Fixed SMP spinlock issue with insight from an old
- * hat that clarified original low level driver design.
- * Version 6.30 Added SMP support; fixed multmode issues. -ml
- * Version 6.31 Debug Share INTR's and request queue streaming
- * Native ATA-100 support
- * Prep for Cascades Project
- * Version 7.00alpha First named revision of ide rearrange
- *
- * Some additional driver compile-time options are in ./include/linux/ide.h
- *
- * To do, in likely order of completion:
- * - modify kernel to obtain BIOS geometry for drives on 2nd/3rd/4th i/f
- *
*/
#define REVISION "Revision: 7.00alpha2"
hwif->straight8 = tmp_hwif->straight8;
hwif->bus_state = tmp_hwif->bus_state;
+ hwif->host_flags = tmp_hwif->host_flags;
+
+ hwif->pio_mask = tmp_hwif->pio_mask;
+
hwif->atapi_dma = tmp_hwif->atapi_dma;
hwif->ultra_mask = tmp_hwif->ultra_mask;
hwif->mwdma_mask = tmp_hwif->mwdma_mask;
hwif->cds = tmp_hwif->cds;
#endif
- hwif->tuneproc = tmp_hwif->tuneproc;
+ hwif->set_pio_mode = tmp_hwif->set_pio_mode;
hwif->speedproc = tmp_hwif->speedproc;
+ hwif->mdma_filter = tmp_hwif->mdma_filter;
hwif->udma_filter = tmp_hwif->udma_filter;
hwif->selectproc = tmp_hwif->selectproc;
hwif->reset_poll = tmp_hwif->reset_poll;
if (arg < 0 || arg > 255)
return -EINVAL;
- if (!HWIF(drive)->tuneproc)
+ if (drive->hwif->set_pio_mode == NULL)
return -ENOSYS;
+
if (drive->special.b.set_tune)
return -EBUSY;
ide_init_drive_cmd(&rq);
struct request rq;
struct request_pm_state rqpm;
ide_task_t args;
+ int ret;
/* Call ACPI _GTM only once */
if (!(drive->dn % 2))
mesg.event = PM_EVENT_FREEZE;
rqpm.pm_state = mesg.event;
- return ide_do_drive_cmd(drive, &rq, ide_wait);
+ ret = ide_do_drive_cmd(drive, &rq, ide_wait);
+ /* only call ACPI _PS3 after both drivers are suspended */
+ if (!ret && (((drive->dn % 2) && hwif->drives[0].present
+ && hwif->drives[1].present)
+ || !hwif->drives[0].present
+ || !hwif->drives[1].present))
+ ide_acpi_set_state(hwif, 0);
+ return ret;
}
static int generic_ide_resume(struct device *dev)
int err;
/* Call ACPI _STM only once */
- if (!(drive->dn % 2))
+ if (!(drive->dn % 2)) {
+ ide_acpi_set_state(hwif, 1);
ide_acpi_push_timing(hwif);
+ }
ide_acpi_exec_tfs(drive);
unsigned long flags;
ide_driver_t *drv;
void __user *p = (void __user *)arg;
- int err, (*setfunc)(ide_drive_t *, int);
+ int err = 0, (*setfunc)(ide_drive_t *, int);
u8 *val;
- err = scsi_cmd_ioctl(file, bdev->bd_disk->queue, bdev->bd_disk, cmd, p);
- if (err != -ENOTTY)
- return err;
-
switch (cmd) {
case HDIO_GET_32BIT: val = &drive->io_32bit; goto read_val;
case HDIO_GET_KEEPSETTINGS: val = &drive->keep_settings; goto read_val;
__ATTR_NULL
};
-static int ide_uevent(struct device *dev, char **envp, int num_envp,
- char *buffer, int buffer_size)
+static int ide_uevent(struct device *dev, struct kobj_uevent_env *env)
{
ide_drive_t *drive = to_ide_device(dev);
- int i = 0;
- int length = 0;
-
- add_uevent_var(envp, num_envp, &i, buffer, buffer_size, &length,
- "MEDIA=%s", media_string(drive));
- add_uevent_var(envp, num_envp, &i, buffer, buffer_size, &length,
- "DRIVENAME=%s", drive->name);
- add_uevent_var(envp, num_envp, &i, buffer, buffer_size, &length,
- "MODALIAS=ide:m-%s", media_string(drive));
- envp[i] = NULL;
+
+ add_uevent_var(env, "MEDIA=%s", media_string(drive));
+ add_uevent_var(env, "DRIVENAME=%s", drive->name);
+ add_uevent_var(env, "MODALIAS=ide:m-%s", media_string(drive));
return 0;
}
projects / linux-2.6-omap-h63xx.git / blobdiff