#include <linux/slab.h>
#include <linux/pci.h>
#include <linux/delay.h>
-#include <linux/hdreg.h>
#include <linux/ide.h>
#include <linux/bitops.h>
#include <linux/nmi.h>
tf_outb(tf->lbah, io_ports->lbah_addr);
if (task->tf_flags & IDE_TFLAG_OUT_DEVICE)
- tf_outb((tf->device & HIHI) | drive->select.all,
+ tf_outb((tf->device & HIHI) | drive->select,
io_ports->device_addr);
}
EXPORT_SYMBOL_GPL(ide_tf_load);
void ide_fixstring (u8 *s, const int bytecount, const int byteswap)
{
- u8 *p = s, *end = &s[bytecount & ~1]; /* bytecount must be even */
+ u8 *p, *end = &s[bytecount & ~1]; /* bytecount must be even */
if (byteswap) {
/* convert from big-endian to host byte order */
- for (p = end ; p != s;)
- be16_to_cpus((u16 *)(p -= 2));
+ for (p = s ; p != end ; p += 2)
+ be16_to_cpus((u16 *) p);
}
+
/* strip leading blanks */
+ p = s;
while (s != end && *s == ' ')
++s;
/* compress internal blanks and strip trailing blanks */
printk(KERN_DEBUG "%s: skipping word 93 validity check\n",
drive->name);
- if (ide_dev_is_sata(id) && !ivb)
+ if (ata_id_is_sata(id) && !ivb)
return 1;
if (hwif->cbl != ATA_CBL_PATA80 && !ivb)
return 1;
no_80w:
- if (drive->udma33_warned == 1)
+ if (drive->dev_flags & IDE_DFLAG_UDMA33_WARNED)
return 0;
printk(KERN_WARNING "%s: %s side 80-wire cable detection failed, "
drive->name,
hwif->cbl == ATA_CBL_PATA80 ? "drive" : "host");
- drive->udma33_warned = 1;
+ drive->dev_flags |= IDE_DFLAG_UDMA33_WARNED;
return 0;
}
ide_hwif_t *hwif = drive->hwif;
const struct ide_tp_ops *tp_ops = hwif->tp_ops;
u16 *id;
- unsigned long timeout, flags;
+ unsigned long flags;
u8 stat;
/*
tp_ops->set_irq(hwif, 0);
msleep(50);
tp_ops->exec_command(hwif, ATA_CMD_ID_ATA);
- timeout = jiffies + WAIT_WORSTCASE;
- do {
- if (time_after(jiffies, timeout)) {
- SELECT_MASK(drive, 0);
- return 0; /* drive timed-out */
- }
- msleep(50); /* give drive a breather */
- stat = tp_ops->read_altstatus(hwif);
- } while (stat & ATA_BUSY);
+ if (ide_busy_sleep(hwif, WAIT_WORSTCASE, 1)) {
+ SELECT_MASK(drive, 0);
+ return 0;
+ }
msleep(50); /* wait for IRQ and ATA_DRQ */
stat = tp_ops->read_status(hwif);
}
local_irq_save(flags);
SELECT_MASK(drive, 0);
- id = kmalloc(SECTOR_WORDS*4, GFP_ATOMIC);
+ id = kmalloc(SECTOR_SIZE, GFP_ATOMIC);
if (!id) {
local_irq_restore(flags);
return 0;
kfree(id);
- if (drive->using_dma && ide_id_dma_bug(drive))
+ if ((drive->dev_flags & IDE_DFLAG_USING_DMA) && ide_id_dma_bug(drive))
ide_dma_off(drive);
return 1;
skip:
#ifdef CONFIG_BLK_DEV_IDEDMA
- if (speed >= XFER_SW_DMA_0 && drive->using_dma)
+ if (speed >= XFER_SW_DMA_0 && (drive->dev_flags & IDE_DFLAG_USING_DMA))
hwif->dma_ops->dma_host_set(drive, 1);
else if (hwif->dma_ops) /* check if host supports DMA */
ide_dma_off_quietly(drive);
drive->special.all = 0;
drive->special.b.set_geometry = legacy;
drive->special.b.recalibrate = legacy;
+
drive->mult_count = 0;
- if (!drive->keep_settings && !drive->using_dma)
+
+ if ((drive->dev_flags & IDE_DFLAG_KEEP_SETTINGS) == 0 &&
+ (drive->dev_flags & IDE_DFLAG_USING_DMA) == 0)
drive->mult_req = 0;
+
if (drive->mult_req != drive->mult_count)
drive->special.b.set_multmode = 1;
}
if (drive->media == ide_disk)
ide_disk_pre_reset(drive);
else
- drive->post_reset = 1;
+ drive->dev_flags |= IDE_DFLAG_POST_RESET;
- if (drive->using_dma) {
+ if (drive->dev_flags & IDE_DFLAG_USING_DMA) {
if (drive->crc_count)
ide_check_dma_crc(drive);
else
ide_dma_off(drive);
}
- if (!drive->keep_settings) {
- if (!drive->using_dma) {
- drive->unmask = 0;
+ if ((drive->dev_flags & IDE_DFLAG_KEEP_SETTINGS) == 0) {
+ if ((drive->dev_flags & IDE_DFLAG_USING_DMA) == 0) {
+ drive->dev_flags &= ~IDE_DFLAG_UNMASK;
drive->io_32bit = 0;
}
return;