ARM: OMAP3: Revert "Make I2C bus 2 configurable for BeagleBoard"

[linux-2.6-omap-h63xx.git] / drivers / i2c / busses / Kconfig

diff --git a/drivers/i2c/busses/Kconfig b/drivers/i2c/busses/Kconfig
index 4b8f400638c1e733ca6d5f1ac6ec8a622e2e2f75..7f95905bbb9d497603985dd02750ecc29e71b92d 100644 (file)
--- a/drivers/i2c/busses/Kconfig
+++ b/drivers/i2c/busses/Kconfig
@@ -418,26 +418,10 @@ config I2C_OMAP
        default y if MACH_OMAP_H3 || MACH_OMAP_OSK
        help
          If you say yes to this option, support will be included for the
-         I2C interface on the Texas Instruments OMAP1/2/3 family of
-         processors.
-         Like OMAP1510/1610/1710/5912, OMAP242x, OMAP34x and OMAP35x.
+         I2C interface on the Texas Instruments OMAP1/2 family of processors.
+         Like OMAP1510/1610/1710/5912 and OMAP242x.
          For details see http://www.ti.com/omap.
 
-config I2C2_OMAP_BEAGLE
-       bool "Enable I2C2 for OMAP3 BeagleBoard"
-       depends on ARCH_OMAP && MACH_OMAP3_BEAGLE
-       select OMAP_MUX
-       default n
-       help
-         Say Y here if you want to enable I2C bus 2 at OMAP3 based
-         BeagleBoard.
-         I2C2 at BeagleBoard is connected to expansion connector, i.e. unused
-         if nothing is connected to this connector. As internal OMAP3 pull up
-         resistors are not strong enough, enabled but unused I2C2 bus results
-         in error messages (e.g. I2C timeouts). Enable this only if you have
-         something connected to I2C2 at board's expansion connector and this
-         extension has additional pull up resistors for I2C2 bus.
-
 config I2C_PASEMI
        tristate "PA Semi SMBus interface"
        depends on PPC_PASEMI && PCI