MODULE_PARM_DESC(ahci_em_messages,
"Set AHCI Enclosure Management Message type (0 = disabled, 1 = LED");
+#if defined(CONFIG_PATA_MARVELL) || defined(CONFIG_PATA_MARVELL_MODULE)
+static int marvell_enable;
+#else
+static int marvell_enable = 1;
+#endif
+module_param(marvell_enable, int, 0644);
+MODULE_PARM_DESC(marvell_enable, "Marvell SATA via AHCI (1 = enabled)");
+
+
static inline int ahci_nr_ports(u32 cap)
{
return (cap & 0x1f) + 1;
"MV_AHCI HACK: port_map %x -> %x\n",
port_map,
port_map & mv);
+ dev_printk(KERN_ERR, &pdev->dev,
+ "Disabling your PATA port. Use the boot option 'ahci.marvell_enable=0' to avoid this.\n");
port_map &= mv;
}
if (!printed_version++)
dev_printk(KERN_DEBUG, &pdev->dev, "version " DRV_VERSION "\n");
+ /* The AHCI driver can only drive the SATA ports, the PATA driver
+ can drive them all so if both drivers are selected make sure
+ AHCI stays out of the way */
+ if (pdev->vendor == PCI_VENDOR_ID_MARVELL && !marvell_enable)
+ return -ENODEV;
+
/* acquire resources */
rc = pcim_enable_device(pdev);
if (rc)