lguest: wire up pte_update/pte_update_defer

[linux-2.6-omap-h63xx.git] / arch / x86 / lguest / boot.c

diff --git a/arch/x86/lguest/boot.c b/arch/x86/lguest/boot.c
index 9fe4ddaa8f6ff1fc53bbe09443d32d733876131c..7822d29b02c7d957b06107cb8f0d6b09465bad42 100644 (file)
--- a/arch/x86/lguest/boot.c
+++ b/arch/x86/lguest/boot.c
@@ -490,11 +490,17 @@ static void lguest_write_cr4(unsigned long val)
  * into a process' address space.  We set the entry then tell the Host the
  * toplevel and address this corresponds to.  The Guest uses one pagetable per
  * process, so we need to tell the Host which one we're changing (mm->pgd). */
+static void lguest_pte_update(struct mm_struct *mm, unsigned long addr,
+                              pte_t *ptep)
+{
+       lazy_hcall(LHCALL_SET_PTE, __pa(mm->pgd), addr, ptep->pte_low);
+}
+
 static void lguest_set_pte_at(struct mm_struct *mm, unsigned long addr,
                              pte_t *ptep, pte_t pteval)
 {
        *ptep = pteval;
-       lazy_hcall(LHCALL_SET_PTE, __pa(mm->pgd), addr, pteval.pte_low);
+       lguest_pte_update(mm, addr, ptep);
 }
 
 /* The Guest calls this to set a top-level entry.  Again, we set the entry then
@@ -1040,6 +1046,8 @@ __init void lguest_init(void)
        pv_mmu_ops.read_cr3 = lguest_read_cr3;
        pv_mmu_ops.lazy_mode.enter = paravirt_enter_lazy_mmu;
        pv_mmu_ops.lazy_mode.leave = lguest_leave_lazy_mode;
+       pv_mmu_ops.pte_update = lguest_pte_update;
+       pv_mmu_ops.pte_update_defer = lguest_pte_update;
 
 #ifdef CONFIG_X86_LOCAL_APIC
        /* apic read/write intercepts */