#include <asm/machvec.h>
#include <asm/io.h>
#include <asm/sh_keysc.h>
-#include <asm/migor.h>
+#include <mach/migor.h>
#include <cpu/sh7722.h>
/* Address IRQ Size Bus Description
static void camera_power_on(void)
{
+ /* Use 10 MHz VIO_CKO instead of 24 MHz to work
+ * around signal quality issues on Panel Board V2.1.
+ */
camera_clk = clk_get(NULL, "video_clk");
- clk_set_rate(camera_clk, 24000000);
+ clk_set_rate(camera_clk, 10000000);
clk_enable(camera_clk); /* start VIO_CKO */
/* use VIO_RST to take camera out of reset */
gpio_set_value(GPIO_PTT3, 0);
}
+static void camera_power(int mode)
+{
+ if (mode)
+ camera_power_on();
+ else
+ camera_power_off();
+}
+
#ifdef CONFIG_I2C
static unsigned char camera_ov772x_magic[] =
{
- 0x09, 0x01, 0x0c, 0x10, 0x0d, 0x41, 0x0e, 0x01,
+ 0x09, 0x01, 0x0c, 0x20, 0x0d, 0x41, 0x0e, 0x01,
0x12, 0x00, 0x13, 0x8F, 0x14, 0x4A, 0x15, 0x00,
0x16, 0x00, 0x17, 0x23, 0x18, 0xa0, 0x19, 0x07,
0x1a, 0xf0, 0x1b, 0x40, 0x1f, 0x00, 0x20, 0x10,
},
.bus_param = SOCAM_PCLK_SAMPLE_RISING | SOCAM_HSYNC_ACTIVE_HIGH |
SOCAM_VSYNC_ACTIVE_HIGH | SOCAM_MASTER | SOCAM_DATAWIDTH_8,
+ .power = camera_power,
.set_capture = ov772x_set_capture,
};
static struct sh_mobile_ceu_info sh_mobile_ceu_info = {
.flags = SOCAM_MASTER | SOCAM_DATAWIDTH_8 | SOCAM_PCLK_SAMPLE_RISING \
| SOCAM_HSYNC_ACTIVE_HIGH | SOCAM_VSYNC_ACTIVE_HIGH,
- .enable_camera = camera_power_on,
- .disable_camera = camera_power_off,
};
static struct resource migor_ceu_resources[] = {