#define AT250X0_PAGE_SIZE 8
/* register board information for at25 driver */
-int __init spi_eeprom_register(int chipid)
+int __init spi_eeprom_register(int busid, int chipid, int size)
{
- static struct spi_eeprom eeprom = {
- .name = "at250x0",
- .byte_len = 128,
- .page_size = AT250X0_PAGE_SIZE,
- .flags = EE_ADDR1,
- };
struct spi_board_info info = {
.modalias = "at25",
.max_speed_hz = 1500000, /* 1.5Mbps */
- .bus_num = 0,
+ .bus_num = busid,
.chip_select = chipid,
- .platform_data = &eeprom,
/* Mode 0: High-Active, Sample-Then-Shift */
};
-
+ struct spi_eeprom *eeprom;
+ eeprom = kzalloc(sizeof(*eeprom), GFP_KERNEL);
+ if (!eeprom)
+ return -ENOMEM;
+ strcpy(eeprom->name, "at250x0");
+ eeprom->byte_len = size;
+ eeprom->page_size = AT250X0_PAGE_SIZE;
+ eeprom->flags = EE_ADDR1;
+ info.platform_data = eeprom;
return spi_register_board_info(&info, 1);
}
/* simple temporary spi driver to provide early access to seeprom. */
static struct read_param {
+ int busid;
int chipid;
int address;
unsigned char *buf;
dev_info(&spi->dev, "spiclk %u KHz.\n",
(spi->max_speed_hz + 500) / 1000);
- if (read_param->chipid != spi->chip_select)
+ if (read_param->busid != spi->master->bus_num ||
+ read_param->chipid != spi->chip_select)
return -ENODEV;
while (len > 0) {
/* spi_write_then_read can only work with small chunk */
.probe = early_seeprom_probe,
};
-int __init spi_eeprom_read(int chipid, int address,
+int __init spi_eeprom_read(int busid, int chipid, int address,
unsigned char *buf, int len)
{
int ret;
struct read_param param = {
+ .busid = busid,
.chipid = chipid,
.address = address,
.buf = buf,