* along with this program; if not, write to the Free Software
* Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA 02111-1307 USA
*/
-#include <linux/config.h>
#include <linux/init.h>
#include <linux/kernel.h>
#include <linux/types.h>
mips_hpt_frequency = (bus_frequency * (4 + reg)) / 4 / 2;
}
-static void __init emma2rh_timer_setup(struct irqaction *irq)
+void __init plat_timer_setup(struct irqaction *irq)
{
/* we are using the cpu counter for timer interrupts */
setup_irq(CPU_IRQ_BASE + 7, irq);
static void inline __init markeins_sio_setup(void)
{
-#ifdef CONFIG_KGDB_8250
- struct uart_port emma_port;
-
- memset(&emma_port, 0, sizeof(emma_port));
-
- emma_port.flags =
- UPF_BOOT_AUTOCONF | UPF_SKIP_TEST;
- emma_port.iotype = UPIO_MEM;
- emma_port.regshift = 4; /* I/O addresses are every 8 bytes */
- emma_port.uartclk = 18544000; /* Clock rate of the chip */
-
- emma_port.line = 0;
- emma_port.mapbase = KSEG1ADDR(EMMA2RH_PFUR0_BASE + 3);
- emma_port.membase = (u8*)emma_port.mapbase;
- early_serial_setup(&emma_port);
-
- emma_port.line = 1;
- emma_port.mapbase = KSEG1ADDR(EMMA2RH_PFUR1_BASE + 3);
- emma_port.membase = (u8*)emma_port.mapbase;
- early_serial_setup(&emma_port);
-
- emma_port.irq = EMMA2RH_IRQ_PFUR1;
- kgdb8250_add_port(1, &emma_port);
-#endif
}
void __init plat_mem_setup(void)
set_io_port_base(KSEG1ADDR(EMMA2RH_PCI_IO_BASE));
board_time_init = emma2rh_time_init;
- board_timer_setup = emma2rh_timer_setup;
_machine_restart = markeins_machine_restart;
_machine_halt = markeins_machine_halt;