config CRIS
bool
default y
+ select HAVE_IDE
+
+config HZ
+ int
+ default 100
source "init/Kconfig"
+source "kernel/Kconfig.freezer"
+
menu "General setup"
source "fs/Kconfig.binfmt"
source arch/cris/arch-v10/drivers/Kconfig
source arch/cris/arch-v32/drivers/Kconfig
+config ETRAX_AXISFLASHMAP
+ bool "Axis flash-map support"
+ select MTD
+ select MTD_CFI
+ select MTD_CFI_AMDSTD
+ select MTD_JEDECPROBE if ETRAX_ARCH_V32
+ select MTD_CHAR
+ select MTD_BLOCK
+ select MTD_PARTITIONS
+ select MTD_CONCAT
+ select MTD_COMPLEX_MAPPINGS
+ help
+ This option enables MTD mapping of flash devices. Needed to use
+ flash memories. If unsure, say Y.
+
config ETRAX_RTC
bool "Real Time Clock support"
depends on ETRAX_I2C
endchoice
+config ETRAX_SYNCHRONOUS_SERIAL
+ bool "Synchronous serial-port support"
+ help
+ Select this to enable the synchronous serial port driver.
+
+config ETRAX_SYNCHRONOUS_SERIAL_PORT0
+ bool "Synchronous serial port 0 enabled"
+ depends on ETRAX_SYNCHRONOUS_SERIAL
+ help
+ Enabled synchronous serial port 0.
+
+config ETRAX_SYNCHRONOUS_SERIAL0_DMA
+ bool "Enable DMA on synchronous serial port 0."
+ depends on ETRAX_SYNCHRONOUS_SERIAL_PORT0
+ help
+ A synchronous serial port can run in manual or DMA mode.
+ Selecting this option will make it run in DMA mode.
+
+config ETRAX_SYNCHRONOUS_SERIAL_PORT1
+ bool "Synchronous serial port 1 enabled"
+ depends on ETRAX_SYNCHRONOUS_SERIAL && (ETRAXFS || ETRAX_ARCH_V10)
+ help
+ Enabled synchronous serial port 1.
+
+config ETRAX_SYNCHRONOUS_SERIAL1_DMA
+ bool "Enable DMA on synchronous serial port 1."
+ depends on ETRAX_SYNCHRONOUS_SERIAL_PORT1
+ help
+ A synchronous serial port can run in manual or DMA mode.
+ Selecting this option will make it run in DMA mode.
+
choice
prompt "Network LED behavior"
depends on ETRAX_ETHERNET
source "drivers/usb/Kconfig"
+source "drivers/uwb/Kconfig"
+
source "arch/cris/Kconfig.debug"
source "security/Kconfig"