avr32: Fix GPIO initcall breakage

[linux-2.6-omap-h63xx.git] / arch / avr32 / boards / atngw100 / setup.c

diff --git a/arch/avr32/boards/atngw100/setup.c b/arch/avr32/boards/atngw100/setup.c
index 65db3d26696566411f76ea5e660d0384a8860b1d..259ceee02b6291c73d4b7cea5e158b40c0628e41 100644 (file)
--- a/arch/avr32/boards/atngw100/setup.c
+++ b/arch/avr32/boards/atngw100/setup.c
@@ -172,8 +172,6 @@ static int __init atngw100_init(void)
         * reserve any pins for it.
         */
 
-       at32_add_system_devices();
-
        at32_add_device_usart(0);
 
        set_hw_addr(at32_add_device_eth(0, &eth_data[0]));
@@ -194,7 +192,7 @@ static int __init atngw100_init(void)
         * PB28/EXTINT3 doesn't; it should be SMBALERT# (for PMBus),
         * but it's not available off-board.
         */
-       at32_select_periph(GPIO_PIN_PB(28), 0, AT32_GPIOF_PULLUP);
+       at32_select_periph(GPIO_PIOB_BASE, 1 << 28, 0, AT32_GPIOF_PULLUP);
        at32_select_gpio(i2c_gpio_data.sda_pin,
                AT32_GPIOF_MULTIDRV | AT32_GPIOF_OUTPUT | AT32_GPIOF_HIGH);
        at32_select_gpio(i2c_gpio_data.scl_pin,