for every clockdomain register write. However, the
extra detail costs some memory.
+config OMAP_SMARTREFLEX
+ bool "SmartReflex support"
+ depends on ARCH_OMAP34XX && TWL4030_CORE
+ help
+ Say Y if you want to enable SmartReflex.
+
+ SmartReflex can perform continuous dynamic voltage
+ scaling around the nominal operating point voltage
+ according to silicon characteristics and operating
+ conditions. Enabling SmartReflex reduces power
+ consumption.
+
+ Please note, that by default SmartReflex is only
+ initialized. To enable the automatic voltage
+ compensation for VDD1 and VDD2, user must write 1 to
+ /sys/power/sr_vddX_autocomp, where X is 1 or 2.
+
+config OMAP_SMARTREFLEX_TESTING
+ bool "Smartreflex testing support"
+ depends on OMAP_SMARTREFLEX
+ default n
+ help
+ Say Y if you want to enable SmartReflex testing with SW hardcoded
+ NVALUES intead of E-fuse NVALUES set in factory silicon testing.
+
+ In some devices the E-fuse values have not been set, even though
+ SmartReflex modules are included. Using these hardcoded values set
+ in software, one can test the SmartReflex features without E-fuse.
+
+ WARNING: Enabling this option may cause your device to hang!
+
config OMAP_RESET_CLOCKS
bool "Reset unused clocks during boot"
depends on ARCH_OMAP
probably do not want this option enabled until your
device drivers work properly.
+config OMAP_BOOT_TAG
+ bool "OMAP bootloader information passing"
+ depends on ARCH_OMAP
+ default n
+ help
+ Say Y, if you have a bootloader which passes information
+ about your board and its peripheral configuration.
+
+config OMAP_BOOT_REASON
+ bool "Support for boot reason"
+ depends on OMAP_BOOT_TAG
+ default n
+ help
+ Say Y, if you want to have a procfs entry for reading the boot
+ reason in user-space.
+
+config OMAP_COMPONENT_VERSION
+ bool "Support for component version display"
+ depends on OMAP_BOOT_TAG && PROC_FS
+ default n
+ help
+ Say Y, if you want to have a procfs entry for reading component
+ versions (supplied by the bootloader) in user-space.
+
+config OMAP_GPIO_SWITCH
+ bool "GPIO switch support"
+ default n
+ help
+ Say Y, if you want to have support for reporting of GPIO
+ switches (e.g. cover switches) via sysfs. Your bootloader has
+ to provide information about the switches to the kernel via the
+ ATAG_BOARD mechanism if they're not defined by the board config.
+
config OMAP_MUX
bool "OMAP multiplexing support"
depends on ARCH_OMAP
Say Y here if you want support for the OMAP Multichannel
Buffered Serial Port.
+config OMAP_MMU_FWK
+ bool "MMU framework support"
+ depends on ARCH_OMAP
+ default n
+ help
+ Say Y here if you want to use OMAP MMU framework support for
+ DSP, IVA1.0 and Camera in OMAP1/2.
+
+config OMAP_MBOX_FWK
+ tristate "Mailbox framework support"
+ depends on ARCH_OMAP
+ default n
+ help
+ Say Y here if you want to use OMAP Mailbox framework support for
+ DSP, IVA1.0 and IVA2 in OMAP1/2/3.
+
choice
prompt "System timer"
default OMAP_MPU_TIMER