#include <linux/err.h>
#include <linux/clk.h>
#include <linux/io.h>
+#include <linux/input.h>
+#include <linux/i2c/twl4030.h>
+#include <linux/mtd/mtd.h>
+#include <linux/mtd/partitions.h>
+#include <linux/mtd/nand.h>
-#include <asm/hardware.h>
+#include <mach/hardware.h>
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
#include <asm/mach/map.h>
+#include <asm/mach/flash.h>
-#include <asm/arch/gpio.h>
-#include <asm/arch/board.h>
-#include <asm/arch/common.h>
+#include <mach/gpio.h>
+#include <mach/board.h>
+#include <mach/common.h>
+#include <mach/hsmmc.h>
+#include <mach/keypad.h>
+#include <mach/gpmc.h>
+#include <mach/nand.h>
+
+#define GPMC_OFF_CONFIG1_0 0x60
+
+static struct mtd_partition omap2evm_nand_partitions[] = {
+ {
+ .name = "X-Loader",
+ .offset = 0,
+ .size = 1 * (64 * 2048),
+ .mask_flags = MTD_WRITEABLE, /* force read-only */
+ },
+ {
+ .name = "U-Boot",
+ .offset = MTDPART_OFS_APPEND,
+ .size = 3 * (64 * 2048),
+ .mask_flags = MTD_WRITEABLE, /* force read-only */
+ },
+ {
+ .name = "U-Boot Environment",
+ .offset = MTDPART_OFS_APPEND,
+ .size = 1 * (64 * 2048),
+ },
+ {
+ .name = "Kernel",
+ .offset = MTDPART_OFS_APPEND,
+ .size = 16 * (64 * 2048), /* 2MB */
+ },
+ {
+ .name = "Ramdisk",
+ .offset = MTDPART_OFS_APPEND,
+ .size = 32 * (64 * 2048), /* 4MB */
+ },
+ {
+ .name = "Filesystem",
+ .offset = MTDPART_OFS_APPEND,
+ .size = MTDPART_SIZ_FULL,
+ }
+};
+
+static struct omap_nand_platform_data omap2evm_nand_data = {
+ .parts = omap2evm_nand_partitions,
+ .nr_parts = ARRAY_SIZE(omap2evm_nand_partitions),
+ .dma_channel = -1, /* disable DMA in OMAP NAND driver */
+};
+
+static struct resource omap2evm_nand_resource = {
+ .flags = IORESOURCE_MEM,
+};
+
+static struct platform_device omap2evm_nand_device = {
+ .name = "omap2-nand",
+ .id = -1,
+ .dev = {
+ .platform_data = &omap2evm_nand_data,
+ },
+ .num_resources = 1,
+ .resource = &omap2evm_nand_resource,
+};
+
+void __init omap2evm_flash_init(void)
+{
+ void __iomem *gpmc_base_add, *gpmc_cs_base_add;
+ unsigned char cs = 0;
+
+ gpmc_base_add = (__force void __iomem *)OMAP243X_GPMC_VIRT;
+ while (cs < GPMC_CS_NUM) {
+ int ret = 0;
+
+ /* Each GPMC set for a single CS is at offset 0x30 */
+ gpmc_cs_base_add = (gpmc_base_add + GPMC_OFF_CONFIG1_0 +
+ (cs * 0x30));
+
+ /* xloader/Uboot would have programmed the NAND
+ * base address for us This is a ugly hack. The proper
+ * way of doing this is to pass the setup of u-boot up
+ * to kernel using kernel params - something on the
+ * lines of machineID. Check if Nand is
+ * configured */
+ ret = __raw_readl(gpmc_cs_base_add + GPMC_CS_CONFIG1);
+ if ((ret & 0xC00) == (0x800)) {
+ /* Found it!! */
+ printk(KERN_INFO "NAND: Found NAND on CS %d \n", cs);
+ break;
+ }
+ cs++;
+ }
+ if (cs >= GPMC_CS_NUM) {
+ printk(KERN_INFO "MTD: Unable to find MTD configuration in "
+ "GPMC - not registering.\n");
+ return;
+ }
+
+ omap2evm_nand_data.cs = cs;
+ omap2evm_nand_data.gpmc_cs_baseaddr = gpmc_cs_base_add;
+ omap2evm_nand_data.gpmc_baseaddr = gpmc_base_add;
+
+ if (platform_device_register(&omap2evm_nand_device) < 0) {
+ printk(KERN_ERR "Unable to register NAND device\n");
+ return;
+ }
+}
static struct resource omap2evm_smc911x_resources[] = {
[0] = {
}
+static struct platform_device omap2_evm_lcd_device = {
+ .name = "omap2evm_lcd",
+ .id = -1,
+};
+
+static struct omap_lcd_config omap2_evm_lcd_config __initdata = {
+ .ctrl_name = "internal",
+};
+
+static int omap2evm_keymap[] = {
+ KEY(0, 0, KEY_LEFT),
+ KEY(0, 1, KEY_RIGHT),
+ KEY(0, 2, KEY_A),
+ KEY(0, 3, KEY_B),
+ KEY(1, 0, KEY_DOWN),
+ KEY(1, 1, KEY_UP),
+ KEY(1, 2, KEY_E),
+ KEY(1, 3, KEY_F),
+ KEY(2, 0, KEY_ENTER),
+ KEY(2, 1, KEY_I),
+ KEY(2, 2, KEY_J),
+ KEY(2, 3, KEY_K),
+ KEY(3, 0, KEY_M),
+ KEY(3, 1, KEY_N),
+ KEY(3, 2, KEY_O),
+ KEY(3, 3, KEY_P)
+};
+
+static struct omap_kp_platform_data omap2evm_kp_data = {
+ .rows = 4,
+ .cols = 4,
+ .keymap = omap2evm_keymap,
+ .keymapsize = ARRAY_SIZE(omap2evm_keymap),
+ .rep = 1,
+ .irq = TWL4030_MODIRQ_KEYPAD,
+};
+
+static struct platform_device omap2evm_kp_device = {
+ .name = "omap_twl4030keypad",
+ .id = -1,
+ .dev = {
+ .platform_data = &omap2evm_kp_data,
+ },
+};
+
static void __init omap2_evm_init_irq(void)
{
- omap2_init_common_hw();
+ omap2_init_common_hw(NULL);
omap_init_irq();
omap_gpio_init();
omap2evm_init_smc911x();
.enabled_uarts = ((1 << 0) | (1 << 1) | (1 << 2)),
};
+static struct omap_mmc_config omap2_evm_mmc_config __initdata = {
+ .mmc [0] = {
+ .enabled = 1,
+ .wire4 = 1,
+ },
+};
+
static struct omap_board_config_kernel omap2_evm_config[] __initdata = {
- {OMAP_TAG_UART, &omap2_evm_uart_config},
+ { OMAP_TAG_UART, &omap2_evm_uart_config },
+ { OMAP_TAG_LCD, &omap2_evm_lcd_config },
+ { OMAP_TAG_MMC, &omap2_evm_mmc_config },
};
static int __init omap2_evm_i2c_init(void)
}
static struct platform_device *omap2_evm_devices[] __initdata = {
- &omap2evm_smc911x_device,
+ &omap2_evm_lcd_device,
+ &omap2evm_smc911x_device,
+ &omap2evm_kp_device,
};
static void __init omap2_evm_init(void)
omap_board_config = omap2_evm_config;
omap_board_config_size = ARRAY_SIZE(omap2_evm_config);
omap_serial_init();
+ hsmmc_init();
+ omap2evm_flash_init();
}
static void __init omap2_evm_map_io(void)
projects / linux-2.6-omap-h63xx.git / blobdiff