#include <asm/mach/arch.h>
#include <asm/mach/map.h>
+#include <linux/dma-mapping.h>
#include <linux/platform_device.h>
-#include <linux/fb.h>
+#include <linux/i2c-gpio.h>
+#include <linux/fb.h>
#include <video/atmel_lcdc.h>
#include <asm/arch/board.h>
* -------------------------------------------------------------------- */
#if defined(CONFIG_MMC_AT91) || defined(CONFIG_MMC_AT91_MODULE)
-static u64 mmc_dmamask = 0xffffffffUL;
+static u64 mmc_dmamask = DMA_BIT_MASK(32);
static struct at91_mmc_data mmc_data;
static struct resource mmc_resources[] = {
.id = -1,
.dev = {
.dma_mask = &mmc_dmamask,
- .coherent_dma_mask = 0xffffffff,
+ .coherent_dma_mask = DMA_BIT_MASK(32),
.platform_data = &mmc_data,
},
.resource = mmc_resources,
* TWI (i2c)
* -------------------------------------------------------------------- */
-#if defined(CONFIG_I2C_AT91) || defined(CONFIG_I2C_AT91_MODULE)
+/*
+ * Prefer the GPIO code since the TWI controller isn't robust
+ * (gets overruns and underruns under load) and can only issue
+ * repeated STARTs in one scenario (the driver doesn't yet handle them).
+ */
+#if defined(CONFIG_I2C_GPIO) || defined(CONFIG_I2C_GPIO_MODULE)
+
+static struct i2c_gpio_platform_data pdata = {
+ .sda_pin = AT91_PIN_PA23,
+ .sda_is_open_drain = 1,
+ .scl_pin = AT91_PIN_PA24,
+ .scl_is_open_drain = 1,
+ .udelay = 2, /* ~100 kHz */
+};
+
+static struct platform_device at91sam9rl_twi_device = {
+ .name = "i2c-gpio",
+ .id = -1,
+ .dev.platform_data = &pdata,
+};
+
+void __init at91_add_device_i2c(struct i2c_board_info *devices, int nr_devices)
+{
+ at91_set_GPIO_periph(AT91_PIN_PA23, 1); /* TWD (SDA) */
+ at91_set_multi_drive(AT91_PIN_PA23, 1);
+
+ at91_set_GPIO_periph(AT91_PIN_PA24, 1); /* TWCK (SCL) */
+ at91_set_multi_drive(AT91_PIN_PA24, 1);
+
+ i2c_register_board_info(0, devices, nr_devices);
+ platform_device_register(&at91sam9rl_twi_device);
+}
+
+#elif defined(CONFIG_I2C_AT91) || defined(CONFIG_I2C_AT91_MODULE)
static struct resource twi_resources[] = {
[0] = {
.num_resources = ARRAY_SIZE(twi_resources),
};
-void __init at91_add_device_i2c(void)
+void __init at91_add_device_i2c(struct i2c_board_info *devices, int nr_devices)
{
/* pins used for TWI interface */
at91_set_A_periph(AT91_PIN_PA23, 0); /* TWD */
at91_set_A_periph(AT91_PIN_PA24, 0); /* TWCK */
at91_set_multi_drive(AT91_PIN_PA24, 1);
+ i2c_register_board_info(0, devices, nr_devices);
platform_device_register(&at91sam9rl_twi_device);
}
#else
-void __init at91_add_device_i2c(void) {}
+void __init at91_add_device_i2c(struct i2c_board_info *devices, int nr_devices) {}
#endif
* -------------------------------------------------------------------- */
#if defined(CONFIG_SPI_ATMEL) || defined(CONFIG_SPI_ATMEL_MODULE)
-static u64 spi_dmamask = 0xffffffffUL;
+static u64 spi_dmamask = DMA_BIT_MASK(32);
static struct resource spi_resources[] = {
[0] = {
.id = 0,
.dev = {
.dma_mask = &spi_dmamask,
- .coherent_dma_mask = 0xffffffff,
+ .coherent_dma_mask = DMA_BIT_MASK(32),
},
.resource = spi_resources,
.num_resources = ARRAY_SIZE(spi_resources),
* -------------------------------------------------------------------- */
#if defined(CONFIG_FB_ATMEL) || defined(CONFIG_FB_ATMEL_MODULE)
-static u64 lcdc_dmamask = 0xffffffffUL;
+static u64 lcdc_dmamask = DMA_BIT_MASK(32);
static struct atmel_lcdfb_info lcdc_data;
static struct resource lcdc_resources[] = {
.id = 0,
.dev = {
.dma_mask = &lcdc_dmamask,
- .coherent_dma_mask = 0xffffffff,
+ .coherent_dma_mask = DMA_BIT_MASK(32),
.platform_data = &lcdc_data,
},
.resource = lcdc_resources,
#endif
+/* --------------------------------------------------------------------
+ * RTC
+ * -------------------------------------------------------------------- */
+
+#if defined(CONFIG_RTC_DRV_AT91RM9200) || defined(CONFIG_RTC_DRV_AT91RM9200_MODULE)
+static struct platform_device at91sam9rl_rtc_device = {
+ .name = "at91_rtc",
+ .id = -1,
+ .num_resources = 0,
+};
+
+static void __init at91_add_device_rtc(void)
+{
+ platform_device_register(&at91sam9rl_rtc_device);
+}
+#else
+static void __init at91_add_device_rtc(void) {}
+#endif
+
+
+/* --------------------------------------------------------------------
+ * RTT
+ * -------------------------------------------------------------------- */
+
+static struct resource rtt_resources[] = {
+ {
+ .start = AT91_BASE_SYS + AT91_RTT,
+ .end = AT91_BASE_SYS + AT91_RTT + SZ_16 - 1,
+ .flags = IORESOURCE_MEM,
+ }
+};
+
+static struct platform_device at91sam9rl_rtt_device = {
+ .name = "at91_rtt",
+ .id = -1,
+ .resource = rtt_resources,
+ .num_resources = ARRAY_SIZE(rtt_resources),
+};
+
+static void __init at91_add_device_rtt(void)
+{
+ platform_device_register(&at91sam9rl_rtt_device);
+}
+
+
+/* --------------------------------------------------------------------
+ * Watchdog
+ * -------------------------------------------------------------------- */
+
+#if defined(CONFIG_AT91SAM9_WATCHDOG) || defined(CONFIG_AT91SAM9_WATCHDOG_MODULE)
+static struct platform_device at91sam9rl_wdt_device = {
+ .name = "at91_wdt",
+ .id = -1,
+ .num_resources = 0,
+};
+
+static void __init at91_add_device_watchdog(void)
+{
+ platform_device_register(&at91sam9rl_wdt_device);
+}
+#else
+static void __init at91_add_device_watchdog(void) {}
+#endif
+
+
/* --------------------------------------------------------------------
* LEDs
* -------------------------------------------------------------------- */
.regs = (void __iomem *)(AT91_VA_BASE_SYS + AT91_DBGU),
};
+static u64 dbgu_dmamask = DMA_BIT_MASK(32);
+
static struct platform_device at91sam9rl_dbgu_device = {
.name = "atmel_usart",
.id = 0,
.dev = {
- .platform_data = &dbgu_data,
- .coherent_dma_mask = 0xffffffff,
+ .dma_mask = &dbgu_dmamask,
+ .coherent_dma_mask = DMA_BIT_MASK(32),
+ .platform_data = &dbgu_data,
},
.resource = dbgu_resources,
.num_resources = ARRAY_SIZE(dbgu_resources),
.use_dma_rx = 1,
};
+static u64 uart0_dmamask = DMA_BIT_MASK(32);
+
static struct platform_device at91sam9rl_uart0_device = {
.name = "atmel_usart",
.id = 1,
.dev = {
- .platform_data = &uart0_data,
- .coherent_dma_mask = 0xffffffff,
+ .dma_mask = &uart0_dmamask,
+ .coherent_dma_mask = DMA_BIT_MASK(32),
+ .platform_data = &uart0_data,
},
.resource = uart0_resources,
.num_resources = ARRAY_SIZE(uart0_resources),
.use_dma_rx = 1,
};
+static u64 uart1_dmamask = DMA_BIT_MASK(32);
+
static struct platform_device at91sam9rl_uart1_device = {
.name = "atmel_usart",
.id = 2,
.dev = {
- .platform_data = &uart1_data,
- .coherent_dma_mask = 0xffffffff,
+ .dma_mask = &uart1_dmamask,
+ .coherent_dma_mask = DMA_BIT_MASK(32),
+ .platform_data = &uart1_data,
},
.resource = uart1_resources,
.num_resources = ARRAY_SIZE(uart1_resources),
.use_dma_rx = 1,
};
+static u64 uart2_dmamask = DMA_BIT_MASK(32);
+
static struct platform_device at91sam9rl_uart2_device = {
.name = "atmel_usart",
.id = 3,
.dev = {
- .platform_data = &uart2_data,
- .coherent_dma_mask = 0xffffffff,
+ .dma_mask = &uart2_dmamask,
+ .coherent_dma_mask = DMA_BIT_MASK(32),
+ .platform_data = &uart2_data,
},
.resource = uart2_resources,
.num_resources = ARRAY_SIZE(uart2_resources),
.use_dma_rx = 1,
};
+static u64 uart3_dmamask = DMA_BIT_MASK(32);
+
static struct platform_device at91sam9rl_uart3_device = {
.name = "atmel_usart",
.id = 4,
.dev = {
- .platform_data = &uart3_data,
- .coherent_dma_mask = 0xffffffff,
+ .dma_mask = &uart3_dmamask,
+ .coherent_dma_mask = DMA_BIT_MASK(32),
+ .platform_data = &uart3_data,
},
.resource = uart3_resources,
.num_resources = ARRAY_SIZE(uart3_resources),
at91_set_A_periph(AT91_PIN_PB1, 0); /* RXD3 */
}
-struct platform_device *at91_uarts[ATMEL_MAX_UART]; /* the UARTs to use */
+static struct platform_device *at91_uarts[ATMEL_MAX_UART]; /* the UARTs to use */
struct platform_device *atmel_default_console_device; /* the serial console device */
void __init at91_init_serial(struct at91_uart_config *config)
*/
static int __init at91_add_standard_devices(void)
{
+ at91_add_device_rtc();
+ at91_add_device_rtt();
+ at91_add_device_watchdog();
return 0;
}
projects / linux-2.6-omap-h63xx.git / blobdiff