APIC APIC support is enabled.
APM Advanced Power Management support is enabled.
AX25 Appropriate AX.25 support is enabled.
+ BLACKFIN Blackfin architecture is enabled.
DRM Direct Rendering Management support is enabled.
EDD BIOS Enhanced Disk Drive Services (EDD) is enabled
EFI EFI Partitioning (GPT) is enabled
acpi_irq_isa= [HW,ACPI] If irq_balance, mark listed IRQs used by ISA
Format: <irq>,<irq>...
+ acpi_no_auto_ssdt [HW,ACPI] Disable automatic loading of SSDT
+
acpi_os_name= [HW,ACPI] Tell ACPI BIOS the name of the OS
Format: To spoof as Windows 98: ="Microsoft Windows"
Format:
<first_slot>,<last_slot>,<port>,<enum_bit>[,<debug>]
- cpia_pp= [HW,PPT]
- Format: { parport<nr> | auto | none }
-
crashkernel=nn[KMG]@ss[KMG]
[KNL] Reserve a chunk of physical memory to
hold a kernel to switch to with kexec on panic.
dtc3181e= [HW,SCSI]
- earlyprintk= [X86-32,X86-64,SH]
+ earlyprintk= [X86-32,X86-64,SH,BLACKFIN]
earlyprintk=vga
earlyprintk=serial[,ttySn[,baudrate]]
Format: <1-256>
maxcpus= [SMP] Maximum number of processors that an SMP kernel
- should make use of.
- Using "nosmp" or "maxcpus=0" will disable SMP
- entirely (the MPS table probe still happens, though).
- A command-line option of "maxcpus=<NUM>", where <NUM>
- is an integer greater than 0, limits the maximum number
- of CPUs activated in SMP mode to <NUM>.
- Using "maxcpus=1" on an SMP kernel is the trivial
- case of an SMP kernel with only one CPU.
+ should make use of. maxcpus=n : n >= 0 limits the
+ kernel to using 'n' processors. n=0 is a special case,
+ it is equivalent to "nosmp", which also disables
+ the IO APIC.
max_addr=[KMG] [KNL,BOOT,ia64] All physical memory greater than or
equal to this physical address is ignored.
nosep [BUGS=X86-32] Disables x86 SYSENTER/SYSEXIT support.
- nosmp [SMP] Tells an SMP kernel to act as a UP kernel.
+ nosmp [SMP] Tells an SMP kernel to act as a UP kernel,
+ and disable the IO APIC. legacy for "maxcpus=0".
nosoftlockup [KNL] Disable the soft-lockup detector.
pt. [PARIDE]
See Documentation/paride.txt.
+ pty.legacy_count=
+ [KNL] Number of legacy pty's. Overwrites compiled-in
+ default number.
+
quiet [KNL] Disable most log messages
r128= [HW,DRM]
-1: disable all active trip points in all thermal zones
<degrees C>: override all lowest active trip points
+ thermal.crt= [HW,ACPI]
+ -1: disable all critical trip points in all thermal zones
+ <degrees C>: lower all critical trip points
+
thermal.nocrt= [HW,ACPI]
Set to disable actions on ACPI thermal zone
critical and hot trip points.