no delay (0).
Format: integer
+ bootmem_debug [KNL] Enable bootmem allocator debug messages.
+
bttv.card= [HW,V4L] bttv (bt848 + bt878 based grabber cards)
bttv.radio= Most important insmod options are available as
kernel args too.
* [no]ncq: Turn on or off NCQ.
+ * nohrst, nosrst, norst: suppress hard, soft
+ and both resets.
+
If there are multiple matching configurations changing
the same attribute, the last one is used.
nolapic_timer [X86-32,APIC] Do not use the local APIC timer.
+ nox2apic [X86-64,APIC] Do not enable x2APIC mode.
+
+ x2apic_phys [X86-64,APIC] Use x2apic physical mode instead of
+ default x2apic cluster mode on platforms
+ supporting x2apic.
+
noltlbs [PPC] Do not use large page/tlb entries for kernel
lowmem mapping on PPC40x.
<deci-seconds>: poll all this frequency
0: no polling (default)
- tipar.timeout= [HW,PPT]
- Set communications timeout in tenths of a second
- (default 15).
-
- tipar.delay= [HW,PPT]
- Set inter-bit delay in microseconds (default 10).
-
tmscsim= [HW,SCSI]
See comment before function dc390_setup() in
drivers/scsi/tmscsim.c.