no delay (0).
Format: integer
+ bootmem_debug [KNL] Enable bootmem allocator debug messages.
+
bttv.card= [HW,V4L] bttv (bt848 + bt878 based grabber cards)
bttv.radio= Most important insmod options are available as
kernel args too.
* [no]ncq: Turn on or off NCQ.
+ * nohrst, nosrst, norst: suppress hard, soft
+ and both resets.
+
If there are multiple matching configurations changing
the same attribute, the last one is used.
or
memmap=0x10000$0x18690000
+ memory_corruption_check=0/1 [X86]
+ Some BIOSes seem to corrupt the first 64k of
+ memory when doing things like suspend/resume.
+ Setting this option will scan the memory
+ looking for corruption. Enabling this will
+ both detect corruption and prevent the kernel
+ from using the memory being corrupted.
+ However, its intended as a diagnostic tool; if
+ repeatable BIOS-originated corruption always
+ affects the same memory, you can use memmap=
+ to prevent the kernel from using that memory.
+
+ memory_corruption_check_size=size [X86]
+ By default it checks for corruption in the low
+ 64k, making this memory unavailable for normal
+ use. Use this parameter to scan for
+ corruption in more or less memory.
+
+ memory_corruption_check_period=seconds [X86]
+ By default it checks for corruption every 60
+ seconds. Use this parameter to check at some
+ other rate. 0 disables periodic checking.
+
memtest= [KNL,X86] Enable memtest
Format: <integer>
range: 0,4 : pattern number
<deci-seconds>: poll all this frequency
0: no polling (default)
- tipar.timeout= [HW,PPT]
- Set communications timeout in tenths of a second
- (default 15).
-
- tipar.delay= [HW,PPT]
- Set inter-bit delay in microseconds (default 10).
-
tmscsim= [HW,SCSI]
See comment before function dc390_setup() in
drivers/scsi/tmscsim.c.