FB The frame buffer device is enabled.
HW Appropriate hardware is enabled.
IA-64 IA-64 architecture is enabled.
+ IMA Integrity measurement architecture is enabled.
IOSCHED More than one I/O scheduler is enabled.
IP_PNP IP DHCP, BOOTP, or RARP is enabled.
ISAPNP ISA PnP code is enabled.
Range: 0 - 8192
Default: 64
+ dma_debug=off If the kernel is compiled with DMA_API_DEBUG support
+ this option disables the debugging code at boot.
+
+ dma_debug_entries=<number>
+ This option allows to tune the number of preallocated
+ entries for DMA-API debugging code. One entry is
+ required per DMA-API allocation. Use this if the
+ DMA-API debugging code disables itself because the
+ architectural default is too low.
+
hpet= [X86-32,HPET] option to control HPET usage
Format: { enable (default) | disable | force |
verbose }
hvc_iucv= [S390] Number of z/VM IUCV hypervisor console (HVC)
terminal devices. Valid values: 0..8
+ hvc_iucv_allow= [S390] Comma-separated list of z/VM user IDs.
+ If specified, z/VM IUCV HVC accepts connections
+ from listed z/VM user IDs only.
i8042.debug [HW] Toggle i8042 debug mode
i8042.direct [HW] Put keyboard port into non-translated mode
ihash_entries= [KNL]
Set number of hash buckets for inode cache.
+ ima_audit= [IMA]
+ Format: { "0" | "1" }
+ 0 -- integrity auditing messages. (Default)
+ 1 -- enable informational integrity auditing messages.
+
+ ima_hash= [IMA]
+ Formt: { "sha1" | "md5" }
+ default: "sha1"
+
in2000= [HW,SCSI]
See header of drivers/scsi/in2000.c.
memtest= [KNL,X86] Enable memtest
Format: <integer>
- range: 0,4 : pattern number
default : 0 <disable>
+ Specifies the number of memtest passes to be
+ performed. Each pass selects another test
+ pattern from a given set of patterns. Memtest
+ fills the memory with this pattern, validates
+ memory contents and reserves bad memory
+ regions that are detected.
meye.*= [HW] Set MotionEye Camera parameters
See Documentation/video4linux/meye.txt.
autoconfiguration.
Ranges are in pairs (memory base and size).
- dynamic_printk Enables pr_debug()/dev_dbg() calls if
- CONFIG_DYNAMIC_PRINTK_DEBUG has been enabled.
- These can also be switched on/off via
- <debugfs>/dynamic_printk/modules
-
print-fatal-signals=
[KNL] debug: print fatal signals
print-fatal-signals=1: print segfault info to