-#ifdef CONFIG_MACH_OMAP_H4_TUSB
-
-#include <linux/usb/musb.h>
-
-static struct musb_hdrc_platform_data tusb_data = {
- .mode = MUSB_OTG,
- .min_power = 25, /* x2 = 50 mA drawn from VBUS as peripheral */
-
- /* 1.8V supplied by Menelaus, other voltages supplied by VBAT;
- * so no switching.
- */
-};
-
-static void __init tusb_evm_setup(void)
-{
- static char announce[] __initdata =
- KERN_INFO "TUSB 6010 EVM\n";
- int irq;
- unsigned dmachan = 0;
-
- /* There are at least 32 different combinations of boards that
- * are loosely called "H4", with a 2420 ... different OMAP chip
- * revisions (with pin mux changes for DMAREQ, GPMC errata, etc),
- * modifications of the CPU board, mainboard, EVM, TUSB etc.
- * Plus omap2422, omap2423, etc.
- *
- * So you might need to tweak this setup to make the TUSB EVM
- * behave on your particular setup ...
- */
-
- /* Already set up: GPMC AD[0..15], CLK, nOE, nWE, nADV_ALE */
- omap_cfg_reg(E2_GPMC_NCS2);
- omap_cfg_reg(L2_GPMC_NCS7);
- omap_cfg_reg(M1_GPMC_WAIT2);
-
- switch ((omap_rev() >> 8) & 0x0f) {
- case 0: /* ES 1.0 */
- case 1: /* ES 2.0 */
- /* Assume early board revision without optional ES2.0
- * rework to swap J15 & AA10 so DMAREQ0 works
- */
- omap_cfg_reg(AA10_242X_GPIO13);
- irq = 13;
- /* omap_cfg_reg(J15_24XX_DMAREQ0); */
- break;
- default:
- /* Later Menelaus boards can support all 6 DMA request
- * lines, at the price of boot flash A23-A26.
- */
- omap_cfg_reg(J15_24XX_GPIO99);
- irq = 99;
- dmachan = (1 << 1) | (1 << 0);
-#if !(defined(CONFIG_MTD_OMAP_NOR) || defined(CONFIG_MTD_OMAP_NOR_MODULE))
- dmachan |= (1 << 5) | (1 << 4) (1 << 3) | (1 << 2);
-#endif
- break;
- }
-
- if (tusb6010_setup_interface(&tusb_data,
- TUSB6010_REFCLK_24, /* waitpin */ 2,
- /* async cs */ 2, /* sync cs */ 7,
- irq, dmachan) == 0)
- printk(announce);
-}
-
-#endif
-
-#if defined(CONFIG_VIDEO_OV9640) || defined(CONFIG_VIDEO_OV9640_MODULE)
-/*
- * Common OV9640 register initialization for all image sizes, pixel formats,
- * and frame rates
- */
-const static struct ov9640_reg ov9640_common[] = {
- { 0x12, 0x80 }, { 0x11, 0x80 }, { 0x13, 0x8F }, /* COM7, CLKRC, COM8 */
- { 0x01, 0x80 }, { 0x02, 0x80 }, { 0x04, 0x00 }, /* BLUE, RED, COM1 */
- { 0x0E, 0x81 }, { 0x0F, 0x4F }, { 0x14, 0x4A }, /* COM5, COM6, COM9 */
- { 0x16, 0x02 }, { 0x1B, 0x01 }, { 0x24, 0x70 }, /* ?, PSHFT, AEW */
- { 0x25, 0x68 }, { 0x26, 0xD3 }, { 0x27, 0x90 }, /* AEB, VPT, BBIAS */
- { 0x2A, 0x00 }, { 0x2B, 0x00 }, { 0x32, 0x24 }, /* EXHCH, EXHCL, HREF */
- { 0x33, 0x02 }, { 0x37, 0x02 }, { 0x38, 0x13 }, /* CHLF, ADC, ACOM */
- { 0x39, 0xF0 }, { 0x3A, 0x00 }, { 0x3B, 0x01 }, /* OFON, TSLB, COM11 */
- { 0x3D, 0x90 }, { 0x3E, 0x02 }, { 0x3F, 0xF2 }, /* COM13, COM14, EDGE */
- { 0x41, 0x02 }, { 0x42, 0xC8 }, /* COM16, COM17 */
- { 0x43, 0xF0 }, { 0x44, 0x10 }, { 0x45, 0x6C }, /* ?, ?, ? */
- { 0x46, 0x6C }, { 0x47, 0x44 }, { 0x48, 0x44 }, /* ?, ?, ? */
- { 0x49, 0x03 }, { 0x59, 0x49 }, { 0x5A, 0x94 }, /* ?, ?, ? */
- { 0x5B, 0x46 }, { 0x5C, 0x84 }, { 0x5D, 0x5C }, /* ?, ?, ? */
- { 0x5E, 0x08 }, { 0x5F, 0x00 }, { 0x60, 0x14 }, /* ?, ?, ? */
- { 0x61, 0xCE }, /* ? */
- { 0x62, 0x70 }, { 0x63, 0x00 }, { 0x64, 0x04 }, /* LCC1, LCC2, LCC3 */
- { 0x65, 0x00 }, { 0x66, 0x00 }, /* LCC4, LCC5 */
- { 0x69, 0x00 }, { 0x6A, 0x3E }, { 0x6B, 0x3F }, /* HV, MBD, DBLV */
- { 0x6C, 0x40 }, { 0x6D, 0x30 }, { 0x6E, 0x4B }, /* GSP1, GSP2, GSP3 */
- { 0x6F, 0x60 }, { 0x70, 0x70 }, { 0x71, 0x70 }, /* GSP4, GSP5, GSP6 */
- { 0x72, 0x70 }, { 0x73, 0x70 }, { 0x74, 0x60 }, /* GSP7, GSP8, GSP9 */
- { 0x75, 0x60 }, { 0x76, 0x50 }, { 0x77, 0x48 }, /* GSP10,GSP11,GSP12 */
- { 0x78, 0x3A }, { 0x79, 0x2E }, { 0x7A, 0x28 }, /* GSP13,GSP14,GSP15 */
- { 0x7B, 0x22 }, { 0x7C, 0x04 }, { 0x7D, 0x07 }, /* GSP16,GST1, GST2 */
- { 0x7E, 0x10 }, { 0x7F, 0x28 }, { 0x80, 0x36 }, /* GST3, GST4, GST5 */
- { 0x81, 0x44 }, { 0x82, 0x52 }, { 0x83, 0x60 }, /* GST6, GST7, GST8 */
- { 0x84, 0x6C }, { 0x85, 0x78 }, { 0x86, 0x8C }, /* GST9, GST10,GST11 */
- { 0x87, 0x9E }, { 0x88, 0xBB }, { 0x89, 0xD2 }, /* GST12,GST13,GST14 */
- { 0x8A, 0xE6 }, { 0x13, 0x8F }, { 0x00, 0x7F }, /* GST15, COM8 */
- { OV9640_REG_TERM, OV9640_VAL_TERM }
-};
-
-static int ov9640_sensor_power_set(int power)
-{
- /* power up the sensor? */
- gpio_set_value_cansleep(H4_GPIO_CAM_MODULE_EN, power);
-
- /* take it out of reset if it's not powered */
- gpio_direction_output(H4_GPIO_CAM_RST, !power);
-
- return 0;
-}
-
-static struct v4l2_ifparm ifparm = {
- .if_type = V4L2_IF_TYPE_BT656,
- .u = {
- .bt656 = {
- .frame_start_on_rising_vs = 1,
- .nobt_vs_inv = 1,
- .mode = V4L2_IF_TYPE_BT656_MODE_NOBT_8BIT,
- .clock_min = OV9640_XCLK_MIN,
- .clock_max = OV9640_XCLK_MAX,
- },
- },
-};
-
-static int ov9640_ifparm(struct v4l2_ifparm *p)
-{
- *p = ifparm;
-
- return 0;
-}
-
-static struct ov9640_platform_data h4_ov9640_platform_data = {
- .power_set = ov9640_sensor_power_set,
- .default_regs = ov9640_common,
- .ifparm = ov9640_ifparm,
-};
-
-#endif
-
-/* leave LCD powered off unless it will be used */
-#if defined(CONFIG_FB_OMAP) || defined(CONFIG_FB_OMAP_MODULE)
-#define LCD_ENABLED true
-#else
-#define LCD_ENABLED false
-#endif
-
-static struct gpio_led backlight_leds[] = {
- {
- .name = "lcd_h4",
- .default_trigger = "backlight",
- .gpio = H4_GPIO_LCD_ENBKL,
- },
- { },
-};
-
-static struct gpio_led_platform_data backlight_led_data = {
- .num_leds = 1,
- .leds = backlight_leds,
-};
-
-static struct platform_device h4_backlight_device = {
- .name = "leds-gpio",
- .id = 0,
- .dev.platform_data = &backlight_led_data,
-};
-
-static int
-u191_setup(struct i2c_client *client, int gpio, unsigned ngpio, void *context)
-{
- /* P0 = IRDA control, FIR/MIR vs SIR */
- gpio_request(H4_GPIO_IRDA_FIRSEL, "irda_firsel");
- gpio_direction_output(H4_GPIO_IRDA_FIRSEL, false);
-
- /* P3 = camera sensor module PWDN */
- gpio_request(H4_GPIO_CAM_MODULE_EN, "camera_en");
- gpio_direction_output(H4_GPIO_CAM_MODULE_EN, false);
-
- /* P7 = LCD_ENVDD ... controls power to LCD (including backlight)
- * P5 = LCD_ENBKL ... switches backlight
- */
- gpio_request(H4_GPIO_LCD_ENVDD, "lcd_power");
- gpio_direction_output(H4_GPIO_LCD_ENVDD, LCD_ENABLED);
- if (LCD_ENABLED) {
- h4_backlight_device.dev.parent = &client->dev;
- platform_device_register(&h4_backlight_device);
- }
-
- /* P6 = AUDIO_ENVDD ... switch power to microphone */
- gpio_request(H4_GPIO_AUDIO_ENVDD, "audio_power");
- gpio_direction_output(H4_GPIO_AUDIO_ENVDD, true);
-
- return 0;
-}
-
-
-static struct pcf857x_platform_data u191_platform_data = {
- .gpio_base = H4_U191_GPIO_BASE,
- .setup = u191_setup,
-};
-
-static int
-u192_setup(struct i2c_client *client, int gpio, unsigned ngpio, void *context)
-{
- gpio_request(H4_GPIO_IRDA_AGPSn, "irda/agps");
- gpio_direction_output(H4_GPIO_IRDA_AGPSn, false);
-
- return 0;
-}
-
-static struct pcf857x_platform_data u192_platform_data = {
- .gpio_base = H4_U192_GPIO_BASE,
- .setup = u192_setup,
-};
-
-static int
-u193_setup(struct i2c_client *client, int gpio, unsigned ngpio, void *context)
-{
- /* reset sensor */
- gpio_request(H4_GPIO_CAM_RST, "camera_rst");
- gpio_direction_output(H4_GPIO_CAM_RST, true);
-
- return 0;
-}
-
-static struct pcf857x_platform_data u193_platform_data = {
- .gpio_base = H4_U193_GPIO_BASE,
- .setup = u193_setup,
-};
-