2 # Touchscreen driver configuration
4 menuconfig INPUT_TOUCHSCREEN
7 Say Y here, and a list of supported touchscreens will be displayed.
8 This option doesn't affect the kernel.
14 config TOUCHSCREEN_ADS7846
15 tristate "ADS7846/TSC2046 and ADS7843 based touchscreens"
17 depends on HWMON = n || HWMON
19 Say Y here if you have a touchscreen interface using the
20 ADS7846/TSC2046 or ADS7843 controller, and your board-specific
21 setup code includes that in its table of SPI devices.
23 If HWMON is selected, and the driver is told the reference voltage
24 on your board, you will also get hwmon interfaces for the voltage
25 (and on ads7846/tsc2046, temperature) sensors of this chip.
27 If unsure, say N (but it's safe to say "Y").
29 To compile this driver as a module, choose M here: the
30 module will be called ads7846.
32 config TOUCHSCREEN_BITSY
33 tristate "Compaq iPAQ H3600 (Bitsy) touchscreen"
34 depends on SA1100_BITSY
37 Say Y here if you have the h3600 (Bitsy) touchscreen.
41 To compile this driver as a module, choose M here: the
42 module will be called h3600_ts_input.
44 config TOUCHSCREEN_CORGI
45 tristate "SharpSL (Corgi and Spitz series) touchscreen driver"
46 depends on PXA_SHARPSL
49 Say Y here to enable the driver for the touchscreen on the
50 Sharp SL-C7xx and SL-Cxx00 series of PDAs.
54 To compile this driver as a module, choose M here: the
55 module will be called corgi_ts.
57 config TOUCHSCREEN_FUJITSU
58 tristate "Fujitsu serial touchscreen"
61 Say Y here if you have the Fujitsu touchscreen (such as one
62 installed in Lifebook P series laptop) connected to your
67 To compile this driver as a module, choose M here: the
68 module will be called fujitsu-ts.
70 config TOUCHSCREEN_GUNZE
71 tristate "Gunze AHL-51S touchscreen"
74 Say Y here if you have the Gunze AHL-51 touchscreen connected to
79 To compile this driver as a module, choose M here: the
80 module will be called gunze.
82 config TOUCHSCREEN_ELO
83 tristate "Elo serial touchscreens"
86 Say Y here if you have an Elo serial touchscreen connected to
91 To compile this driver as a module, choose M here: the
92 module will be called elo.
94 config TOUCHSCREEN_MTOUCH
95 tristate "MicroTouch serial touchscreens"
98 Say Y here if you have a MicroTouch (3M) serial touchscreen connected to
103 To compile this driver as a module, choose M here: the
104 module will be called mtouch.
106 config TOUCHSCREEN_MK712
107 tristate "ICS MicroClock MK712 touchscreen"
109 Say Y here if you have the ICS MicroClock MK712 touchscreen
110 controller chip in your system.
114 To compile this driver as a module, choose M here: the
115 module will be called mk712.
117 config TOUCHSCREEN_HP600
118 tristate "HP Jornada 6xx touchscreen"
119 depends on SH_HP6XX && SH_ADC
121 Say Y here if you have a HP Jornada 620/660/680/690 and want to
122 support the built-in touchscreen.
124 To compile this driver as a module, choose M here: the
125 module will be called hp680_ts_input.
127 config TOUCHSCREEN_HP7XX
128 tristate "HP Jornada 7xx touchscreen"
129 depends on SA1100_JORNADA720_SSP
131 Say Y here if you have a HP Jornada 710/720/728 and want
132 to support the built-in touchscreen.
134 To compile this driver as a module, choose M here: the
135 module will be called jornada720_ts.
137 config TOUCHSCREEN_PENMOUNT
138 tristate "Penmount serial touchscreen"
141 Say Y here if you have a Penmount serial touchscreen connected to
146 To compile this driver as a module, choose M here: the
147 module will be called penmount.
149 config TOUCHSCREEN_TOUCHRIGHT
150 tristate "Touchright serial touchscreen"
153 Say Y here if you have a Touchright serial touchscreen connected to
158 To compile this driver as a module, choose M here: the
159 module will be called touchright.
161 config TOUCHSCREEN_TOUCHWIN
162 tristate "Touchwin serial touchscreen"
165 Say Y here if you have a Touchwin serial touchscreen connected to
170 To compile this driver as a module, choose M here: the
171 module will be called touchwin.
173 config TOUCHSCREEN_TSC2005
174 tristate "TSC2005 touchscreen support"
176 Say Y here for if you are using the touchscreen features of TSC2301.
178 config TOUCHSCREEN_TSC2102
179 tristate "TSC 2102 based touchscreens"
180 depends on SPI_MASTER
183 Say Y here if you have a touchscreen interface using the
184 TI TSC 2102 controller, and your board-specific initialization
185 code includes that in its table of SPI devices. Also make
186 sure the proper SPI controller is selected.
188 If unsure, say N (but it's safe to say "Y").
190 To compile this driver as a module, choose M here: the
191 module will be called tsc2102_ts.
193 config TOUCHSCREEN_TSC210X
194 tristate "TI TSC210x based touchscreens"
195 depends on SPI_MASTER
198 Say Y here if you have a touchscreen interface using a
199 TI TSC210x controller, and your board-specific initialisation
200 code includes that in its table of SPI devices.
202 If unsure, say N (but it's safe to say "Y").
204 To compile this driver as a module, choose M here: the
205 module will be called tsc210x_ts.
207 config TOUCHSCREEN_TSC2301
208 tristate "TSC2301 touchscreen support"
209 depends on SPI_TSC2301
211 Say Y here for if you are using the touchscreen features of TSC2301.
213 config TOUCHSCREEN_UCB1400
214 tristate "Philips UCB1400 touchscreen"
217 This enables support for the Philips UCB1400 touchscreen interface.
218 The UCB1400 is an AC97 audio codec. The touchscreen interface
219 will be initialized only after the ALSA subsystem has been
220 brought up and the UCB1400 detected. You therefore have to
221 configure ALSA support as well (either built-in or modular,
222 independently of whether this driver is itself built-in or
223 modular) for this driver to work.
225 To compile this driver as a module, choose M here: the
226 module will be called ucb1400_ts.
228 config TOUCHSCREEN_WM97XX
229 tristate "Support for WM97xx AC97 touchscreen controllers"
232 Say Y here if you have a Wolfson Microelectronics WM97xx
233 touchscreen connected to your system. Note that this option
234 only enables core driver, you will also need to select
235 support for appropriate chip below.
239 To compile this driver as a module, choose M here: the
240 module will be called wm97xx-ts.
242 config TOUCHSCREEN_WM9705
243 bool "WM9705 Touchscreen interface support"
244 depends on TOUCHSCREEN_WM97XX
246 Say Y here if you have a Wolfson Microelectronics WM9705
247 touchscreen controller connected to your system.
251 config TOUCHSCREEN_WM9712
252 bool "WM9712 Touchscreen interface support"
253 depends on TOUCHSCREEN_WM97XX
255 Say Y here if you have a Wolfson Microelectronics WM9712
256 touchscreen controller connected to your system.
260 config TOUCHSCREEN_WM9713
261 bool "WM9713 Touchscreen interface support"
262 depends on TOUCHSCREEN_WM97XX
264 Say Y here if you have a Wolfson Microelectronics WM9713 touchscreen
265 controller connected to your system.
269 config TOUCHSCREEN_WM97XX_MAINSTONE
270 tristate "WM97xx Mainstone accelerated touch"
271 depends on TOUCHSCREEN_WM97XX && ARCH_PXA
273 Say Y here for support for streaming mode with WM97xx touchscreens
274 on Mainstone systems.
278 To compile this driver as a module, choose M here: the
279 module will be called mainstone-wm97xx.
281 config TOUCHSCREEN_USB_COMPOSITE
282 tristate "USB Touchscreen Driver"
283 depends on USB_ARCH_HAS_HCD
286 USB Touchscreen driver for:
287 - eGalax Touchkit USB (also includes eTurboTouch CT-410/510/700)
288 - PanJit TouchSet USB
289 - 3M MicroTouch USB (EX II series)
291 - some other eTurboTouch
294 - IRTOUCHSYSTEMS/UNITOP
296 - GoTop Super_Q2/GogoPen/PenPower tablets
298 Have a look at <http://linux.chapter7.ch/touchkit/> for
299 a usage description and the required user-space stuff.
301 To compile this driver as a module, choose M here: the
302 module will be called usbtouchscreen.
304 config TOUCHSCREEN_USB_EGALAX
306 bool "eGalax, eTurboTouch CT-410/510/700 device support" if EMBEDDED
307 depends on TOUCHSCREEN_USB_COMPOSITE
309 config TOUCHSCREEN_USB_PANJIT
311 bool "PanJit device support" if EMBEDDED
312 depends on TOUCHSCREEN_USB_COMPOSITE
314 config TOUCHSCREEN_USB_3M
316 bool "3M/Microtouch EX II series device support" if EMBEDDED
317 depends on TOUCHSCREEN_USB_COMPOSITE
319 config TOUCHSCREEN_USB_ITM
321 bool "ITM device support" if EMBEDDED
322 depends on TOUCHSCREEN_USB_COMPOSITE
324 config TOUCHSCREEN_USB_ETURBO
326 bool "eTurboTouch (non-eGalax compatible) device support" if EMBEDDED
327 depends on TOUCHSCREEN_USB_COMPOSITE
329 config TOUCHSCREEN_USB_GUNZE
331 bool "Gunze AHL61 device support" if EMBEDDED
332 depends on TOUCHSCREEN_USB_COMPOSITE
334 config TOUCHSCREEN_USB_DMC_TSC10
336 bool "DMC TSC-10/25 device support" if EMBEDDED
337 depends on TOUCHSCREEN_USB_COMPOSITE
339 config TOUCHSCREEN_USB_IRTOUCH
341 bool "IRTOUCHSYSTEMS/UNITOP device support" if EMBEDDED
342 depends on TOUCHSCREEN_USB_COMPOSITE
344 config TOUCHSCREEN_USB_IDEALTEK
346 bool "IdealTEK URTC1000 device support" if EMBEDDED
347 depends on TOUCHSCREEN_USB_COMPOSITE
349 config TOUCHSCREEN_USB_GENERAL_TOUCH
351 bool "GeneralTouch Touchscreen device support" if EMBEDDED
352 depends on TOUCHSCREEN_USB_COMPOSITE
354 config TOUCHSCREEN_USB_GOTOP
356 bool "GoTop Super_Q2/GogoPen/PenPower tablet device support" if EMBEDDED
357 depends on TOUCHSCREEN_USB_COMPOSITE